Where is the abs module on a 1999 nissan quest please

SOURCE: 1999 nissan quest brake pad replacement

Remove wheel & tire,
remove 2 torx bolts that go from the inside to the outside of the vehicle. They are on the inner side of the brake caliper.
lift the caliper out of the rotor.
remove the brake pads.
To install, you must first squeeze the caliper piston back inot its bore. Do this slowly to prevent damage to the piston. You are forcing excess brake fluid back into the master cylinder reservoir. Slow constant pressure will get the job done. Use a large c clamp or a wooden hammer handel if that's all you have.
Fit the new brake pads in the calipers and slide the assembly back over the rotor.
install the 2 torx bolts, size 40? head I think.
You are done.
If rotors are scored bad, replace them too.

Dar

• 2007 Answers
• Posted on Jun 17, 2009

SOURCE: Looking for a Fuse panel diagram for my Nissan quest 1999

Just check your fuses with a test light. Turn the key on, ground the test light to the door hinge, and touch the silver part on the back side of the fuse, on each side. There should be power to each side. If there isn't, that fuse is burnt.

SOURCE: 1999 Nissan Quest washer tank

Visit the site below for the needed parts:-

http://www.autozone.com/autozone/catalog/parts/partsLanding.jsp;jsessionid=A1http://www.autozone.com/autozone/catalog/parts/partsLanding.jsp;jsessionid=A1672379B5D3BFE00C4009668E08563C.diyprod2-b2c3?landingPage=parts&itemId=0-0672379B5D3BFE00C4009668E08563C.diyprod2-b2c3?landingPage=parts&itemId=0-0

Rate this solution.

SOURCE: 1999 Nissan Quest. Driver side brake lock up. The

possible brake hose collapsing , interrior deterioration

SOURCE: how do you replace the abs sensor on a nissan

simply remove 10mm bolt on the hub however more than likely it will be rusted in the hole on the hub. I had to remove hub bearing assm. and push the sensor out with a screwdriver from the inside. then track the wire where it plugs inside engine compartment and unhook and plug back in. hope this helps