I replaced the head gasket of my fiat uno 1.4 pacer. and now I need to put the timing belt back, so now I need step by step instructions on how to set the cam and crack pulley's on there marks an then put the cam belt back
SOURCE: need clyinder head bolt settings
22ft lbs 1st pass 33ftlbs 2nd pass 90 degrees final pass in alternating sequence
SOURCE: I removed the timming belt of a fiat uno 1983-1985
PULL OUT NO 1 SPARK PLUG PUT A SCREW DRIVER DOWN THE HOLE AND TURN THE ENGINE OVER BY HAND UNTIL THE SCREW DRIVER IS AT THE TOP THEN YO WILL SEE THE MARKS ON THE CRANK OR LOOK AT THE TIMMING COVER IT SHOULD SHOW YOU TDC
189 views
Usually answered in minutes!
×