It's under the dash, passenger side. Remove the glove box door, glove box, disconnect the BCM from the glove box, look waaaaay under the dash ,almost center, up against the firewall ,for a 2 wire line that plugs into a white plastic part that has two bolts holding it in place. That's the resistor.
. Why do you believe that is what is causing a problem?
Please let me know what is going on, I have replaced this on my car, it was extremely difficult, and wasn't the problem at all.
SOURCE: locating heater blower motor resistor
the resistor is behind your glove box. open the box and push in the sides to release it and let it hang down...the resistor is right there. I didn't try to replace it, a friend did it, but the part was under $20.
SOURCE: Low speeds on Blower Motor do not work.
this is caused by a burnt out blower motor speed control resistor module.
SOURCE: have to change blower motor resistor where is it located
Located behind glovebox. 2 screws and 2 plugs. very simple
SOURCE: help with location and replacing blower motor resistor
depends on what year van..1996-2000,located in engine compartment just above right strut tower at firewall..2001-2007..located behind glove box
SOURCE: 2001 Saturn L200 Sedan blower motor relay location
it's by the firewall pass side in the plastic blower box. Multi wire plug and two screws are showing.
372 views
Usually answered in minutes!
×