2002 Saturn L-Series Logo
Anonymous Posted on Jan 31, 2013

Saturn sl1 blower fan speed resistors

Location of blower speed control resistors in Saturn SL1

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

  • Contributor 22 Answers
  • Posted on Jan 31, 2013
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Jan 31, 2013
Answers
22
Questions
1
Helped
4323
Points
77

Should be next to the blower or where passenger feet is at the black box down there u should be able to pull straight down and it right there

  • Anonymous Jan 31, 2013

    My problem is the passenger compartment fan starts then quits after 1 mt. turn off for 3-4 mt and turn on the fan repeats, to me sounds like a thermal fuse or a problem with the speed resistors. Fan draws 7 amp at 12v turns freely by hand no burning at fan terminals. I have taken the dash apart including the air bag out there is nothing there. The fan switch wiring runs in to the main harness up behind the main console across the too left side of the dash there is a break out into a black box with two plug connectors. The box contains the piezio sounder, a processor and a couple of 3 pin semi's. The main part of the harness then appears to go into the engine compartment. The relay fuse block under the center console has no sign of a burned connector. I did a visual inspection of all connectors and fuse/relay terminals.

×

5 Related Answers

Charlie

  • 280 Answers
  • Posted on Jun 25, 2008

SOURCE: 1994 saturn SL1

This vehicle has an electronic variable orifice rack and pinion steering system.
Charlie

Ad

Anonymous

  • 1 Answer
  • Posted on Jan 17, 2009

SOURCE: saturn sl1

my car is leaking antifreeze near the pullyes no hoses are leaking
so what can it be

Anonymous

  • 48 Answers
  • Posted on Jan 27, 2009

SOURCE: replaceing coil pack on 1996 saturn sl1

Sounds like the Ignition Control Module.

Anonymous

  • 71 Answers
  • Posted on Jan 05, 2010

SOURCE: where is the location of the heater blower motor

No need to tear the dash out. The blower is located above the passenger's feet, below the glove compartment. You access it from underneath. Three small black bolts hold it on and there is a two wire electrical connector on the bottom that must be removed. The motor drops down with the fan blade attached. Should take about 5 or 10 minutes to remove.

I have a '93 SL2 and the interior is the same as an SL1 or 2 from '92, '93, '94 and maybe even a '95.

Testimonial: "Fantastic job in your response! Thank you so much!"

Anonymous

  • 3911 Answers
  • Posted on Apr 26, 2010

SOURCE: Saturn SL1 Rear Bumper repair & replace cost?

Call junkyards, look on ebay or craigslist, and find out. You are obviously going to need a used part. Having located a used part, find a mechanic to find out how much the labor will be.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

1998 Saturn SL1 1.9Ltr Enginer, blower motor resistor I need a diagram how to replace it please

screws on the top of the dash in the Saturn. Then pry the dashboard up and away. This may seem like a pain to get to, but it's a must if you want to fix the heater blower motor resistor.
2helpful
1answer

Where is the blower motor resistor located on my 1996 saturn sl1, and what does it look like? the blower just quit working.

this resistor is located on the lower rightside of the dash, it is next to blowermotor and is in heater box, this part slides into heater box and is held in by two screws, its like a T it slides into the box and then the top of the T sits outside the heater box and two screws hold it, heres a picture of the resistor , hope this is helpful.johnjohn2_35.jpg
0helpful
1answer

What controls heat and a/c vents on 1999 Saturn Sl1 looking at one to buy the lever doesn't work

What controls the air flow of the heat and A/C would be the blower motor. Blower motor is located below the dash on the passenger side.
3helpful
1answer

Where is the computer on a 1997 Saturn SL1?

For 1997 Saturn SL1 1.9L MFI SOHC 4cyl the Engine Control Computer is located in seating area, driver side, behind dash, upper corner, mounted on dash support brackets.

Hope help with this (remember comment and rated this).
3helpful
2answers

The blower motor quit in my 2000 sl1 saturn

check the hvac fuse. if its ok you can check the heater control resistor. its mounted in the heater box usually on the passenger side under the dash. these are cheep and available at your local parts store
2helpful
1answer

2000 saturn sl1 the heater blows cold air, i have change the thermostit, had the the cooling system flushed, change the resistor on the heater.

I too have a 2000 saturn sl1 with a heating problem...PLEEEEASE help me diagnose this prob.... Anyone got any suggestions???
2helpful
2answers

2000 satin sl1 heater blows cold air, had the

my 2000 saturn sl blows cold air with the heater on. I changed the thermostat,and checked out my heater core.Still blows cold air.
4helpful
1answer

Where is the location of the heater blower motor on a 1994 saturn sl1? Do I have to tear the dash out?

No need to tear the dash out. The blower is located above the passenger's feet, below the glove compartment. You access it from underneath. Three small black bolts hold it on and there is a two wire electrical connector on the bottom that must be removed. The motor drops down with the fan blade attached. Should take about 5 or 10 minutes to remove.

I have a '93 SL2 and the interior is the same as an SL1 or 2 from '92, '93, '94 and maybe even a '95.
0helpful
2answers

Replaceing coil pack on 1996 saturn sl1

looking at the motor follow the plug wires down to the coil pack located lower middle of engine.take wires of making note were they are posistioned unplug electrical connection should be 3 bolts 10mm. heads.then remove
Not finding what you are looking for?

356 views

Ask a Question

Usually answered in minutes!

Top Saturn Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...