Hazard flashers work turn signals dont where is the relay switch under the dash

The flasher units are different for turn signals and four way flashers. Not sure but most are under the dash not far from the steering column

Fast clicking is caused by a higher than normal current being applied. Normally a short or a aftermarket relay that requires less current to switch. Sounds like the entire multifunction switch is bad.

I think you might have a separate flasher for the turn signals under the dash. The turn and hazard flasher would look alike. Turn you hazards on and find the flasher for it under the dash. You will probably be able to feel it working and hear it clicking. The other flasher under the dash is for the turn signals. Try replacing that one. I think it was in later years they began to combine the two into a single composite flasher.

Sure.
The hazards and turn signals each have a flasher.
They are different, both look like a small relay. You may have to get the turn signal flasher from Ford. You may want to check with them to see what the part looks like to make sure you are working on the right one.
They are generally under the dash on the driver side.

Actually there is a relay however it is not an individual part. The turn signal relay and the hazard relay are in the LCM (Lighting Control Module). This is expensive to replace however you should test the multi-function turn signal switch first as I am having the exact same problem with my 95 Crown Victoria LX. If you go to any parts store they will tell you that it is just a relay and sell you one for the newer Crown Victoria models. However in the 95 to about 2002 models they employed the bad idea of the LCM.Good luck.

There are 2 separate flasher relays. 1 for the turn signals and one for the hazards. I believe you have a bad flasher relay for the turn signals. The location of that is in the front seating area on the drivers side, under the dash on the drivers side of the steering column, mounted on support bracket. I provided a picture of what it should kind of look like although the picture I gave you is an aftermarket one so the color and such may be a little different but will look the same. Don't get it mixed up with the hazard relay which is located in the front seating area on the drivers side under the dash above the kick pane lmounted on top of the convenience. I am almost 100 percent sure the flasher and hazard relay are the same so if you want to just swap them out in order to have turn signals that should work. You won't have hazards however. I hope this helps you and good luck.

First check turn signal fuse and relay if, they are good then try pressing on and off the hazard switch while turning the signal switch on.If signals start to work replace hazard switch.If hazard switch is good then replace turn signal switch.

Try replacing the Flasher Relay. It has 2 relays, one for the turn signals and one for the hazard lights. The one for the turn signals is located Front seating area, driver side, under dash, behind instrument panel, mounted on passenger side of steering column.
The hazard flasher is located Front seating area, driver side, under dash, above kick panel, mounted in top of convenience panel.
Replace the Turn signal flasher.
Curtorsey: Auto Zone.

I NEED TO LOCATE THE SWITCH WHERE IS IT ?
MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME
SO THERE MUST BE A RELAY SWITCH SOMEWHER BUT DONT KNOW WHERE ?
THANKS FOR HELPING

the hazard switch above the radio is your problem. if you put on your signals and they don't flash turn hazards on then off and they will flash. (changing this *** will fix your problem