2002 Buick Park Avenue Logo

Related Topics:

Anonymous Posted on Jun 21, 2009

2002 park ave heat on drivers side a/c on pass want a/c on drivers

  • Anonymous Jun 21, 2009

    it is all elertic modes

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

  • Contributor 1 Answer
  • Posted on Jun 21, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Joined: Jun 21, 2009
Answers
1
Questions
0
Helped
112
Points
3

Its a vacuum leak from your temp.control unit

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

02Park Ave is blowing warm air on passenger side, but not drivers side nor windshield or heater

Are you able to control the driver side air temperature at the dash registers? If not and you can control the passenger side of the dual climate system then you have an issue with the air temperature control door (moves between the heater core heated air and the AC evaporator cold air stream) deep inside the dash or the electric actuator that moves it or in most cases both.
0helpful
1answer

Bought 2000 buick park ave. ultra & do not know how to adj drivers seat up or down.

should have buttons on your armrest or down on the side of the seat by the drivers door if not check in front of the seat
0helpful
1answer

Buick park ave 1997. Hot air on drivers side, cold on passenger???

either the air duct under the dash is broken or diconnected, or you have a broken or disconnected vacume hose or line. unless you have seperate/digital controls for dr/pass air. if that is the case then you need to replace dr side control unit.
3helpful
1answer

I have a 1998 buick park ave ultra and the driver side air blows heat and the pass side blows cold

assuming you have an electronic controlled (digital) dual zone system, it is most likely your heater blend door motor has failed, check and see which side is operating and buy the one you need and replace, it has 2 or 3 screws on the side, i think size is 4.5 mm or 5.5 mm and you have to take off lower plastic cover under dash and remove screws which go on horizontally... install heater door with temp swithched to the middle, move door to middle, if not you need to place new motor into plug before installing and turn temp to cold, then turn by hand the white blend door tube to match motor then install... make sure you turn off ignition when working,,,
1helpful
1answer

1996 Buick Park Ave -Hot air on driver side -Cold air pass. side

Behind the glove box you will see the heater box. On top of the heater box you will see a set of wires going to a small controller box that has an arm on it. It is probably not working and you can only by them at the dealer. It is the dual climate controller and cost approx. $100.
12helpful
1answer

Drivers heated seat quit working, 2002 buick regal

most likely you will be dealing with broken seat element. locate harness connector for heating element under seat and ck for power with test lite. just experienced same problem in a 2000 park ave
0helpful
1answer

'99 Park Ave, No drivers heat

Check the operation of the drivers blend door actuator. Sounds like its stuck or broken. Does the temp display on the dash flash?
Not finding what you are looking for?

122 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...