Those not change gears and the clutch is all the way to the floor
Check your clutch master cylinder's fluid,it's located under hood in right corner,if low or empty,then your slave cylinder is bad and leaking,it's connected to side of transmission.Here's a link. Repair Guides Clutch Clutch Release Cylinder AutoZone com Here's the part. Duralast Clutch Slave Cylinder 12425 1992 Nissan Datsun D21 Truck 2WD 4...
SOURCE: Clutch cable just fixed and just started to stick to floor again
Check each end of the cable, there should be a clamp that holds the cable casing in place. If the
clamp became loose, when you step on the peddle
it would pull the cable and case not the clutch fork.
And the result would be, what you have now.
I hope this was of some help.
SOURCE: my clutch goes to the
The cable may need to be replaced or adjusted. Or if it is a hydraulic clutch check the master and slave cylinders for leaks or defects. If you have a cable clutch you will see the cable on the drivers side firewall and you can follow it down to the fork at the transmission.
551 views
Usually answered in minutes!
×