What fuse needs to be replaced for 2006 Hyundai elantra radio
SOURCE: Elantra's thermostat
dear friend:please look were the engine and gearbox joins together there is a housing were the radiator hose fits from the radiator,remove that housing and you will find the thermostat,
SOURCE: 2002 hyundai elantra radio and dome light not working
Then 1, bulbs are burned out
OR 2, the wiring is faulty.
Testimonial: "thanx for the solution. took the car to a repair shop and was told that the wiring was faulty. had the car rewired."
SOURCE: How to replace 2004 Hyundai Elantra starter
First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.
SOURCE: how to replace 2002 hyundai elantra hub and bearing
With the car on ground, break loose the drive-axle nut, and the wheel nuts , than jack up the car, support it properly, remove the wheel ,remove the axle-nut.
Remove the brake caliper assembly-- support it properly.
Remove the two bolts that hold the hub bracket to the Macpherson strut assemble, remove the lower arm ball joint and remove the steering tie- rod ball-joint attached to the hub bracket. That's it.Slide off the hub /with the bracket off the drive-shaft.
Follow steps backwards to assemble back.
100 views
Usually answered in minutes!
×