Question about 2001 Jeep Grand Cherokee
I suggest visit your service local and check Line Pressure Sensor Circuit.
Posted on Nov 27, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.
Posted on May 01, 2009
yah direct ignition coil pack does away for the need a a distributer cap and rotor.much higher energy ignition system where the computer tell when to fire.if that helps.not hard to change.as long as you change them one at a time so you don't screw up the order.
Posted on Nov 28, 2009
First, if the noise is from the upper part of the engine and is more of a tapping than a knock, likely you have a problem in the valvetrain, most often a bad lifter or worn rocker arm. If the noise is low, deep inside, the noise is from a bearing. This is generally accompanied by lower than normal oil pressure. Regardless of the underlying cause, correcting the cause will not stop the knock. To do that correctly, the engine needs to be removed and all crankshaft bearings and the crankshaft itself need to be replaced (crank can sometimes be "undercut" and thicker bearing shells can be used depending upon the amount of wear.) If caught very early, sometimes only one bearing can be replaced in-car, but in 99% of all cases I have ever seen, most will fail again, sometimes more severely if done this way.
Posted on Dec 10, 2009
P0733=Gear 3 Incorrect Ratio
P0734=Gear 4 Incorrect Ratio,
your transmission is in "limp" mode,
Have the following sensors checked on the transmission,input sensor,output sensor,and speed sensor.
The transmission is not getting a signal from one of them,So it doesn't know how fast your going so it doesn't up shift.
Posted on Jan 22, 2010
Tips for a great answer:
Oct 22, 2015 | Cars & Trucks
Nov 26, 2012 | 2001 Jeep Grand Cherokee
Nov 30, 2010 | 2001 Jeep Grand Cherokee
Jan 08, 2010 | 2001 Jeep Grand Cherokee
Sep 28, 2009 | 2001 Jeep Grand Cherokee
Sep 03, 2009 | 2001 Jeep Grand Cherokee
Feb 28, 2009 | 2001 Jeep Grand Cherokee
Jan 27, 2009 | 2001 Jeep Grand Cherokee
188 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: