2005 Chevrolet Aveo Running Light Issue

2005 Chevy Aveo - engine light and hold lights flash - Fixya

www.fixya.com/.../t1361856-2005_chevy_aveo_engine_light_hold_ligh...

Dec 11, 2008 - 2005 Chevy Aveo - engine light and hold lights flash Yesterday I had my ... When I started the car to come home they started flashing again.

Chevrolet Aveo Transmission Problems - Car Forums at Edmunds.com

forums.edmunds.com > Chevrolet > Chevrolet Aveo

Sep 23, 2010 - 30 posts - ‎19 authors
Next time it jumps out of gear to push the onstar button and have it towed to .... to either start in 3rd gear (absolutely no power from a cold start until .... The car has beenstuck in park in both situations, level ground and ... My automatic 2005 Chevy Aveo LS requires T-IV Automatic Transmission Fluid (GM pt.

Engine light lit ? Have it checked for DTC'S - diagnostic trouble code's ! Do you know what DTC'S are for ?

The switch that control the daytime running light will need a whole replacement

Erase the code and drive it. If it sets a code again or runs poorly, see if any new code(s) are set.

i need a diagram for o4 aveo rear brake shoe/springs assembly

CHECK DRL FUSE MAKE SURE ITS IN PLACE TIGHT.IF FUSE GOOD RELAY COULD BE GOING BAD.

What is the code? Auto Zone uses cheap scanners, but the code is what you need. For example if you get a P1651 OBDII code the sensor that controls the fan relay could be running the cooling fans at night when the car is turned off and running down your battery. For a few bucks your local GM dealer can scan it for you, and you should have the answer. If you just get the code's Write them down, If you don't have a service manual, search the net for OBDII with the code# and that should narrow the problem down to circuit that is causing the problem. Hope this help.

If the light was flashing when it came on, then it means your engine is misfiring.
A solid light can mean anything.

This light comes on when the computer detects a fault of some sort in its diagnostic tests. If it keeps detecting this issue, the light will remain off. If the light turns off, then it has detected that the issue may no longer be present.

In order to find out what the exact reason was for your light, You need to have your car computer scanned to retrieve the code that the computer would have stored when the light triggered. Most garages will do this free of charge. The code will tell you what may have caused the light to initially go on

It sounds like you should check for power at brake pedal switch. Hook up a test light to the switch and press the brake pedal. If the light does not go on and you have power in the wires to the switch then the switch should be replaced.
I hope this helps you out

I doubt the gas cap is related to the light, though hopefully you can get a replacement for it because it can be dangerous. As for the check engine light I'm not sure what it could be. Is the car running making noises, does it stall?? If there are no obvious symptoms, you might need to take it to a mechanic so they can read the error message from the cars computer and determine where th eproblem is.