Can't find the oil distick on pontiac g5 2008

12-13 foot pounds

Pontiac Engine Torque Specs

Butler Performance https://butlerperformance.com > p-34888-pontiac-engi...
Pontiac Engine Torque Specs ; Oil Pump Cover Bolts, Engine Oil, 15 ft-lbs. ; Windage Tray, Engine Oil, 15 ft-lbs. ; Oil Pan, Engine Oil, 12 ft-lbs. ; Camshaft ...

Oil and Transmission Pan Bolts. How much torque?

GMForum.com https://www.gmforum.com > ... > 1992-1999
Jun 12, 2003 - the Torque Specifications for the Xmission Oil Pan Bolts are 12-13 Ft. Lbs. Works for me.

Transmission pan Torque spec
Apr 28, 2017
4T65E-HD transmission pan bolt torque values
Feb 8, 2008
More results from www.gmforum.com

2004 Pontiac Sunfire 2-dr Transmission Pan Gasket ...

MyCarSpecs https://www.mycarspecs.com > pontiac > sunfire > 2004
The transmission pan gasket helps to seal in transmission fluid and keep it from leaking everywhere. This will degrade over time and need replacement, ...

..

You can find the oil life monitor reset procedure here

Oil Change Light Reset Pontiac G8 2008 2009 Reset Your Oil Change Light

No, Monica, you have to add dipstick to your fluid. ? Don't stay clueless, lurnn !
Amazing. I just re-read your post (over and over), and it made sense. Really, I'm sorry for ribbing you, and you are not clueless, you just don't know how to talk to mechanics!

If the oil is really dirty- been there a long time, or you know, black and syrupy- then , yes, do change it with a new oil filter too. Probably not causing it to die out, but oil is there to protect the engine from burning out all the moving parts inside it. That's why it's so important to keep the oil full on the dipstick, and clean. Just like the anti-freeze, too, another big concern for your toyota. When you get it running again, the clean oil will make a difference, it will run better. For dying, check fuel...check or have someone put in a new gas filter. Start somewhere. Good luck. Post back for more!
.

junk yard or a pick-n-pull type yard is probably the cheapest way to go. if ya cant find one there i think you can order them off the internet cheep it will just cost more for shipping hope that helps.

REPLACE THE DISTICK THE RUBBER AROUND THE STICK TENDS TO SWELL OVER TIME AND DOESNT ALLOW IT TO SEAT PROPERLY SO IT WILL POP OUT

4.5 qts

What about blow-by gas? Has it got excessive pressure? you can determine this by pulling the distick out while engine is running and check the pressure of the gas.

Whenever you have excessive pressure in the crankcase, it's usually a sign of severe engine wear. Typically piston rings that are no longer sealing well and combustion pressure is "blowing by" into the oil pan pushing oil and vapor out of the engine wherever it can. It's time to rebuild the engine.

You have to unbolt the distick to check the fluid. Its on the lower, front side of the drivers side, left of the battery and straight down, behind 2 hoses. My dipstick is green (Aero) and is easier to remove from under the car.

Pull the distick and smell the oil. If it's discoloured (black or dark brown) you know the transmission friction plates are burnt and needs a rebuilt.
Cheers