Probably the high beam relay.
where is the high beam relay?
Check your owners manual, it should be in the relay box near the battery.
nope,I thought it was going to br that easy
I went back and looked at the wiring diagram, it says the relays are in the fuse box on the left side of the dash where the headlight fuses are.
will check thanks
×
SOURCE: 1998 dodge dakota v8 magnum headlight problem
headlight switch is overheating ... replace it be sure to check the plug on the harness making sure it did not melt. the design is poor too many wires going thru one switch. It will go bad again and again especially if you do alot of night driving or use your high beams alot.and by no means use any other headlights other then factory issue.
SOURCE: My headlights wont turn off on my 2003 dodge intrepid
I own the same year make and model. The headlights are supposed to stay on for a few minutes if you shut them off after shutting off the engine. This is a safety feature. These are the headlights only. If the lights, side markers and taillights stay on, then the issue is most likely the switch. You will have to pull the switch and disconnect the wiring harness to confirm this. If the lights go out, then the switch is bad.
However, if the lights don't go out, or the headlights never shut off until they drain the battery, you may want to take the car in to get diagnosed. There could be an issue with the body control module or wiring. Most likely, it is the switch as Chrysler uses the cheapest parts for their switches, but I would check it first and not swap parts. All you have to do to check the switch is pull the bezel it sit in out of the dash. The switch is held in with two screws.
SOURCE: how to fix the gauges on a 1997 dodge intrepid?
check your instrument panel fuse in the fuse box, the instrument cluster is operated by the same circuit
SOURCE: 94 dodge intrepid wont start
clicking in the fusebox? And the starter could be because you need a new one. or a rebuilt. The clicking is your starter cylinoid.
SOURCE: 2002 Dodge Intrepid accessory/starter relay problem?
Accessory position is turning key towards he driver. Ignition on is away 1 and start is away2.
168 views
Usually answered in minutes!
×