Question about 1993 Buick LeSabre

1 Answer

What part do i need for a massive tune up on a 2000 crown victory

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 91 Answers

Find out your engine size/type and buy the following: Engine belt, Spark Plugs, Spark plug wires, Oil filter, Min.of 6 qts oil, Air filter, maybe get a bottle of fuel injector cleaner, Fuel filter would be good(Get the ford A/C and Fuel line tool. usually $20), Maybe get a Lucas style transmission fluid additive, this should all cost $150-$200. and covers pretty much all the major areas of a tune-up.

Posted on Feb 24, 2009

1 Suggested Answer

  • 1 Answer

SOURCE: massive tune up for a 2000 crown victory

Plugs, Direct ignition modules should be checked for conductivity and resistance,oil, oil filter, 14 quarts of tranny fluid, tranny filter,oil, oil filter, serpentine belt, tensioner pulley setup ( cops beat on these motors) fuel filter, flush the coolant system ( a new radiator is great for these cars), timing belt, purple oil for the rear end, Id either ad Lucas (my first chioce) or marvel mystery oil for the motor, tranny, and rear end, as long as there isnt any serious trouble mechanicaly this will condtion the moving parts and reduce breakdown of those partts. Other than that i think you'd be wasting money, i work at a dealer that specializes in goverment cars, ive seen theese steps bring a car that wont move and barely run, to a dependable daily driver. good luck

Posted on Mar 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove a rev limiter from a crown victory


That function is usually handled by a program in the ecm. Unless you get a chip burned to change the properties of the ECM, there is nothing you can do.

Feb 09, 2015 | 2006 Ford Crown Victoria

1 Answer

I have a '97 4.6 ford crown vic. Only starts up when i apply gas n dies when i let off the pedal any ideas?


Most likely the Idle Air Control Motor, but you could have other issues suck as a leaking fuel pressure regulator, bad EGR valve, or massive vacuum leak.

Dec 01, 2014 | 1997 Ford Crown Victoria

1 Answer

Massive evap leak ck engine light on needs ny inspection


almost alway a vacuum line with a hole in it or off

May 28, 2011 | 1997 Ford Crown Victoria

1 Answer

Fuse diagram for 2000 crown victoria


there are 5+ pages of fuses what specifically do you need


Jul 30, 2010 | 2000 Ford Crown Victoria

1 Answer

Engine is jumping


Check fuel filter and fuel pump, a clogged filter can cause loss of power during acceleration and a malfunctioning pump can cause the same thing

Jun 19, 2009 | 2000 Ford Crown Victoria

1 Answer

Massive tune up for a 2000 crown victory


Plugs, Direct ignition modules should be checked for conductivity and resistance,oil, oil filter, 14 quarts of tranny fluid, tranny filter,oil, oil filter, serpentine belt, tensioner pulley setup ( cops beat on these motors) fuel filter, flush the coolant system ( a new radiator is great for these cars), timing belt, purple oil for the rear end, Id either ad Lucas (my first chioce) or marvel mystery oil for the motor, tranny, and rear end, as long as there isnt any serious trouble mechanicaly this will condtion the moving parts and reduce breakdown of those partts. Other than that i think you'd be wasting money, i work at a dealer that specializes in goverment cars, ive seen theese steps bring a car that wont move and barely run, to a dependable daily driver. good luck

Feb 24, 2009 | 2000 Ford Crown Victoria

2 Answers

My 2000 crown vics engine runs rough in park at mid throttle,and drives like i am on a bumpy road at mid throttle,replaced shocks, tires, balancing,alignment. please help


I suggest you look at or have the engine looked at, for air intake obstructions, engine mount problems, or possiblt drive shaft/u-joint problems. Those are my best guesses for your problem description. Good luck!

Sep 14, 2008 | 2005 Ford Crown Victoria

Not finding what you are looking for?
1993 Buick LeSabre Logo

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...