EPB and Auto Hold light of hyundai genesis 2012 are On whats the problem?

Question edited for clarity.
Question moved to model category from 'Misc'.

It is a known issue

https://www.google.com/search?q=2011+Genesis+What+causes+the+EPB+and+Auto+light+to+randomly+come+on#

..

This is a known issue. Contact the dealership of Hyundai head office.

https://www.google.com/search?q=2012+Hyundai+Genesis.+The+radio+will+not+cut+off

..

what do is 100% ignore any tpms lamp. for ever.
so far 13 years now . we own pressure gauge.
and know how and when to use it. every month and
we kick the tires before we light the fires. now for 100 years.
genesis or genesis coup, they can be very very different
TPMS RECEIVER right not the initiator?
now the words in the book you will not like.
When the receiver first arrives for replacement:

1. It will be in Virgin State.
2. It will not be configured for any specific platform.
3. It will not have any sensor ID''s memorized.

model rec
High Line (95800-3M100)


here is there horrible drawing, I don't like korean cars
the translation the english is no good.
but there it is , the RECEIVER. and plastic panels must be removed
that is obvious as below is steel frames below for side impact protection. so plastics off it is. and buy the service manual is best or google for ever.



if all sensors fail, NOT TOLD
the initiator my be bad (my guess the transmitter)
located in a different place
see next post

There is a procedure for emergency EPB release, which is worth a try to make it go temporarily;
Turn off engine.

Select P if auto, apply foot brake.
Push and hold EPB switch/lever down.
Turn ignition on, wait for system check to cycle.
Start engine.
Release EPB switch/lever.
The EPB should have now released

No just the one that fits.

I would return it to the installer

My 2012 Hyundai Elantra Wont Start - CarGurus

www.cargurus.com > Questions > Hyundai > Elantra

CarGurusJul 30, 2013 - My 2012 hyundai Elantra GLS would not start this morning. ... I hit my door unlock on mt Key fab and the doors unlocked fromt here I proceeded start my car.... it and it wont turn over just makes a light click. not like a battery issue. .... But if Istart from the zero position on the starter it doesn't start on the first try ...

No horn / No lights when I lock my car - Hyundai Genesis ...

www.gencoupe.com/.../244433-no-horn-no-lights-when-i-lock-my-car.h...

Mar 30, 2014 - 16 posts - ‎8 authors
I do not know what could have caused this but when i lock my car... ... lock yourdoors with your key fob(might have to hit the lock button twice) ... The alarm/horn should start beeping. ... 2010 Hyundai Genesis Coupe 2.0T R-spec in Karussel White.... My lights flash when I lock it, but the horn doesn't sound.

2013 Hyundai Elantra Engine Won't Turnover, Won't Start ...

www.carcomplaints.com/.../Elantra/.../engine_wont_turnover_wont_start...

The 2013 Hyundai Elantra has 19 complaints for engine won't turnover, won't ...

Sure, it's under warranty, take it to a dealer

I did a quick Google search and found P0128 may indicate a stuck thermostat. The engine is not warming up properly. There are other causes: A code P0128 may mean that one or more of the following has happened:
* Low engine coolant level
* Leaking or stuck open thermostat
* Faulty cooling fan (running too much)
* Faulty coolant temperature (ECT) sensor
* Faulty intake air temperature (IAT) sensor
I got most this info from another thread on Fixya. I hope that it helps you.

I would check the coil those wires are probably on the same coil

Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop manuals, service bulletins, illustrations and procedures, etc.