An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: Heater blower does not work.
You can get a dirgram off of the intrenet on the fuse panel of your car. Are you can go to a junk yard and get a cover out of a wreck car like yours. one more thing, get a meter and ohm the fuse across the two little metal **** on top of the fuse. If the fuse is good, the meter will read or make a sound, depends on your meter.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
you may have a problem with the heater core flap that allows coolant into the core. seems like there is just not enougg coolant going through the core. check to make sure the heat/cool selector is working properly.
The fuse box should be located under the hood of your 06 nissan quest. You have to remove its cover and underneath the cover there should be a diagram just locate the turn signal fuse location check what amperage it is (should be stamped with 10, 20 etc...) go to the auto parts store get a replacement fuse install it in the fuse box and off you go... Hope this helps...
REMOVE HEATER BLOWER MOTOR AND HOT WIRE IT.IF HEATER BLOWER MOTOR WORKS WHEN HOT WIRED EITHER BLOWER RELAY BAD OR AC AND HEATER CONTROL SWITCH NOT WORKING.IF BLOWER DONT WORK WHEN HOT WIRED BLOWER MOTOR IS BAD.
usually its the heater fan resistor that is bad. it controls the fan speeds for blower motor. The blower motor is mounted under the glove box. It is in the corner somewhat covered by the kick panel. The card, at least on my pathfinder, is held in with 2 phillips head screws. The plug has 4 wires, one large wire and 3 smaller wires. You should see it very near to and parallel with the firewall.
The card has an on board fuse that is not replaceable. It is located on the passenger side fire wall to the left of the blower moter under the glove box. Held in with two silver phillps screws
Look in engine compartment close to battery for fuse box, remove cover and inside cover there is a diagram of fuse/relay locations.
You are looking for a fuse and relay, it should say blower fan or AC blower fan. First check fuse, if Fuse is ok. check Relay.
Good Luck!! Don't forget to rate this post!!
Under the dash to the lreft of the steering wheel you will find the fuse box, it will have a black plastic cover over it, remove the cover and look at the diagram printed on the cover, the heater blower motor fuse is #9, it is a 30 amp fuse.
"ENGINE COMPARTMENT CAUTION Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipment does not come on, check for an open fuse. 1. Be sure the ignition switch and the headlight switch are OFF. 2. Open the engine hood. 3. Remove the fuse box cover by pushing the tab and lifting the cover up. 4. Locate the blown fuse. or look on fuse box cover to see what each fuse does. 5. Remove the fuse with the fuse puller. The fuse puller is located in the center of the fuse block in the passenger compartment." Replace fuse.