Question about 2004 Nissan XTerra

Open Question

How to remove the side marker light nissan xterra 2004

How to remove the side marker light assembly in nissan xterra 2004? what tools do i need?

Posted by on

6 Suggested Answers

SUL827
  • 93 Answers

SOURCE: Replace tail light

Unbolt the lamp and pull off body, replace bulb and check you work before final assembly.

Posted on Sep 16, 2008

emissionwiz
  • 61252 Answers

SOURCE: How to remove frount break rotors on 2004 Xterra 4wd

All you need to do is unbolt the front brake calipers and the rotors just slide on and off.

Posted on Nov 06, 2008

  • 1861 Answers

SOURCE: 1996 toyota corolla side marker light removal to install new one

Open the hood. Observe the "tab" on the driver side inner fender, above the corner of the headlamp, outer edge. Remove the screw. Pull the lamp assembly straight forward, towards you. If it has never been out, the lamp will be tight. There are 2 locking pins inside the fender that need to be defeated, you just have to grasp the back side of the lamp (closest to the driver door) and pull it straight towards the front of the car, NOT sideways.

Posted on Dec 23, 2008

  • 16 Answers

SOURCE: parking lights nissan 2002 xterra

Open the back lift door. Inside next to the lights there are screws that need to be removed before you can get the whole parking light off. After you get the screws out, you will have to force the whole plastic light cover to get to the burn out light. Once you get the whole light out, replace the bulb and follow the process in reverse.

Posted on Jul 08, 2009

  • 19 Answers

SOURCE: how to change front driver side 2004 g35 coupe marker light

Just pop out the side marker from where the marker meets the fender well and push outward on the side marker. It has a metal clip retaining it to the bumper.

This entry was in January, most likely you figured it out already.

Posted on Jul 13, 2009

  • 6 Answers

SOURCE: change brake light on 2006 Xterra

After you remove the 2 bolts there is 2 cone shaped tensioners that help hold the taillight housing on. Grab the taillight firmly on the top and bottom, and pull it straight towards you until the tensioners pop. They will not be damaged and are made to pop in and out.
Then find the bulb housing of the burnt bulb, turn the housing clockwise, and remove the bulb housing, remove the bulb by pulling on the black base of the bulb only on the short sides on the housing. (DO NOT pull on the glass, as it may break in your hand). Then slide the replacement bulb into the housing (it can go in either direction), and repeat the steps in reverse order. to put the housing and taillight back on.
Be careful to tighten the taillight bolts by hand only, they have a plastic thread sleeve that is easily stripped by a drill.

Posted on Dec 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dashboard lights dont turn on as well as tail tights


If you confirm the side marker lights,tail lights,fog lights and/or dash illumination are inop,and fuse number 39 is open,the wire harness is chafed/damaged at either the left or right front side marker lights....Removed both front side marker light and repair the harness wil fix your problem.....Let me know if you find any damaged wire harness

Nov 09, 2013 | 2002 Nissan Xterra

1 Answer

How do I pop the tail light off on a 2002 Nissan Xterra to change the bulb?


remove the two visble 10 mm screws.

Do not use any tools trying to pry the assembly out.

Just use your hands and you will not break anything.

Using your two hands, pull towards you firmly shaking the assembly and it will come out.

Jan 13, 2010 | 2002 Nissan Xterra

1 Answer

How to change side marker bulb in 1997 altima


a53bade.gif

The marker lights are removed by depressing the tab (arrow) with a thin bladed tool. Take care not to scratch the paint

  1. Disengage the bulb and socket assembly from the lens housing.
  2. Gently grasp the light bulb and pull it straight out of the socket.
To install:
  1. Before installing the light bulb into the socket, ensure that all electrical contact surfaces are free of corrosion or dirt.
  2. Line up the base of the light bulb with the socket, then insert the light bulb into the socket until it is fully seated.
  3. To ensure that the replacement bulb functions properly, activate the applicable switch to illuminate the bulb which was just replaced. If the replacement light bulb does not illuminate, either it too is faulty or there is a problem in the bulb circuit or switch. Correct as necessary.
  4. Install the socket and bulb assembly into the lens housing.

Dec 07, 2009 | 1997 Nissan.5 Altima

1 Answer

How do you get the front marker light cover off to change the bulb in a 2004 Nissan xterra


you cant take the cover off, remove the light and the bulb goes in from behind, usually 1 or 2 screws

Oct 19, 2009 | 2004 Nissan XTerra

2 Answers

Taillight out on 2001 xterra


Pop your rear tailgate. Look inside for an access panel(s). In SUV's they're usually right behind the light assemblies on the inside. They'll either have screws or pop-outs. You may even have to remove part of the interior panel.

Once the panel is removed, access the light panel from behind and remove bulbs.

Feb 10, 2009 | 2004 Nissan XTerra

1 Answer

2001 Nissan Xterra


Most likely corrosion on the sending unit connector. If corroded will need sending unit assembly. To check lift up passenger side rear seat cushion and remove the top and bottom plates, fuel tank sender is right below.

Aug 23, 2008 | 2001 Nissan Xterra

1 Answer

Continuous Blown Fuse


You have a short. With these Xterras it is most likely from one of the front side markers rubbing the bumper support. Is the front bumper pushed in or damaged in anyway if so check the wiring to these lamps. Hope this helps.

Aug 13, 2008 | 2004 Nissan XTerra

2 Answers

Replace tail light


Rubber seal has adhered to body. Hit the llamp with side of you fist to dislodge,

Jul 19, 2008 | 2004 Nissan XTerra

1 Answer

SIDE MARKER LIGHT, PASSENGER SIDE


Assuming you are talking about the side marker bulb in the bumper, you need to get behind the bumper and un bolt the lens from the back side to change lens or if just bulb replacement twist socket counterclockwise to remove from lens and then change bulb. Keep in mind if the bumper has been hit this will be very difficult to do unless you loosen up bumper and pull out.

Jul 17, 2008 | 2003 Nissan Xterra

Not finding what you are looking for?
2004 Nissan XTerra Logo

Related Topics:

822 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...