4x4 does not work lights dont come on when you turn 4x4 switch on
SOURCE: 1998 ford expedition 4x4 not
Today I fixed the vacuum lines to the front differential (nee transaxle). I had trouble finding parts in the local auto store that would do the trick - but I got something cobbled together. Based on my experience, I can go back to the store and get the right parts for a proper fit.
As of now, 4WD will engage but will not disengage - clearly one of the connections is still poor, or I accidentally switched the ports, or the vacuum shift motor (attached to the front differential) is shot (obviously from abuse).
As near as I can tell, once I switch into 4WD-HI, it will not shut off. 4WD-LO will engage and disengage properly. If I turn the car off for a while, a couple of times 4WD has disengaged. Hmmm...
SOURCE: 1998 ford expedition blinking overdrive light
This blinking light indicates a problem. You will have to have it scanned for trouble codes to find out
what it is.
SOURCE: 2003 ford expedition tail turn signal light dont
You say the rear tail turn signals are not working are the fronts working? If the fronts work and the rears don't then you have a wire issue. Check the grounds for the tail lights or check and see if a trailer wire harness was put in by splicing the wires. Also check for brake lights and see if they work should be same bulb. If the fronts do not work either check fuse 18 in the fuse box should be a 10 amp or check brake fuse 2 which is a 20 amp
SOURCE: 1998 ford expedition wont start. theft like is
If you are reseting a factory alarm...lock and unlock the drivers door with the key.
If you don't know the code look under the dash driver side in left corner there should be a black cover with a sticker with a code on it 6 numbers that is the factory code.
SOURCE: door ajar light stays on
just spray the door latches with lubricant be sure the oil penetrates the internal machanism.
37 views
Usually answered in minutes!
×