How do i install ignition switch on 2000 dodge durango

ricky horwood

• 128 Answers
• Posted on Dec 27, 2008

SOURCE: how to tow a 2003 5.7 liter dodge durango

i am glad you asked
thats i the problem with the electronic select FWD system
when towing a FWD you should put both selectors in neutral this frees the transfer case and the drive shafts
how ever with the electronic system i dont know if it stays in neutral when the car is disconnected from the battery.
so you can make some tryles

1. put the car in neutral in both selectors "gear and FWD" while the car is running when all the warning bell and stuff have gone off turn off the car
   
2. now see if the car can be pushed or towed while the battery is connected
   
3. now disconnect the battery and follow step 2
   
4. if this works then all is well
   

SOURCE: I have a 2000 dodge durango, I have a code P0320.

I put in a new crank positioning sensor and it fixed my problem. 42.00 dollars from NAPA. took about 2 hours to change it.

SOURCE: replace thermostat in 2000 durango

If you look down on the radiator, on the left side, there is a larrge hose coming out of the radiator toward the engine. Where the hose ends there is a housing with 2 bolts. The Thermostat is found under that. Remove the 2 bolts an replace the thermostat. Unles your arms are very long and thin, you will probably need to do this from under the car.
Perfect time to flush/fill all coolant. Check and replace any needed hoses/clamps.

SOURCE: loacte the fuel filter on 2000 dodge durango 4.7 liter v8

if i am not mistaken the fuel filter is built into the fuel pump. which requires you to drop the tank and replace both.

SOURCE: 2000 dodge durango driver side window problem

durangos have many problems with the windows motors and regulators, I know for personal experience , because I have one, ...when you try rolling the windows down do you hear any noise coming from inside the door..if so.. the cable is busted ..you will need the windows regulator, if no, is probably the motor..you will have to check for power and ground right at the motor connector...if power and ground are present, then you need a motor ....in mine ,I pull the motor and cleaned , and they have been fine for more than a year, I starter with one and them had to do the same to all of them..hope this help