After filling the tank and add a injector cleaner
SOURCE: 2005 mercury mariner charging probles
if the altinator is only charging 12.8 volts then its bad. it should be charging 13 to 14 volts
SOURCE: Side Marker Bulbs
you need to remove entire assembly to access bulbs.it is secured by small hex head screws & a ''sliding tab'',an L shaped piece you pry up w/a flat screwdriver.
SOURCE: resetting check engine light
Disconnect negative terminal on Battery for 5 minutes.If this does not work take to your nearest OReillys stroe and they will reset it for you for free
SOURCE: What is the factory code for the keyless entry
factory code is located in the owner's wallet card in the glvoe box
SOURCE: I have a spare keyless entry remote for my 2005
How to reprogram your keyless entry remote controls (97-up) Ford/Lincoln/Mercury
It is necessary to have ALL (maximum of four-original and/or new) of your remote transmitters available prior to beginning this procedure
To program the transmitters yourself:
1. Insert a key in the ignition and turn from 3(Off) to 4(On) eight times in rapid succession (within 10 seconds) with the eighth turn ending in the 4(On) position.
2. The doors will lock/unlock to confirm that programming mode has been entered.
3. Within 20 seconds, program a remote transmitter by pressing any button on a transmitter. The doors will lock/unlock to confirm that the remote transmitter has been programmed. (If more than 20 seconds pass before pressing a remote transmitter button, the programming mode will exit and the procedure will have to be repeated.)
4. Repeat the previous step to program additional remote transmitters. The doors will lock/unlock to confirm that each remote transmitter has been programmed.
5. When you have completed programming the remote transmitters, turn th ignition to 3(Off) or wait 20 seconds. Again the doors will lock/unlock to confirm programming has been completed.
1,209 views
Usually answered in minutes!
Check that gas cap is on
Peter Z. The gas cap is on, and warning message remains
And you have to have the car checked for codes & diagnosed by a repair shop that was what I said before,Just as you have in the past with any vehicle
×