Turn signals and brake lights wont work
SOURCE: 2001 dodge ram 1500 brake lights
I would guess the brake fuse ( this does not use the same fuse as the tail lights/blinkers) or the ground for the brake light bulb.
SOURCE: the brake lights wont work on my 2001 dodge caravan
Sound like the brake light switch is gone. this part is attached to the brake pedal.
SOURCE: my 98 dodge ram 2500 turbo diesel 2wd's rear
My story Dealing with Dodge
I had a 1994 Dodge Ram. The Red Dodge Ram I had it malfunctioned and my brake became the throttle.
I had to put the truck in reverse then park. to stop, after it was out of control at 80 mph a hill slowed us down. Are you sure
its not electrical and the curse control is not giving you trouble?
Mine had multifunction switch was not working and the headlight switch burned up. I also found out that Audi had problem with the brake becoming the throttle
in the 1980s Daimler Chrysler and Audi were German made. I don't think
there is an easy answer. I hope you stay safe. Another man is having
strange trouble also. I'm sure there are many more people with trouble
with the vehicles. I wish Dodge would step up to the truth. and recall
their nightmares. I saw many of their 1996 Dodge trucks at their
dealers shop with all the electrical pulled out.
SOURCE: o2 Dodge Dakota Brake lights wont work but bulbs r good.
If the bulbs are good I would suspect the Brake light switch.
Brake Light Switch: Testing and Inspection
The brake lamp switch can be tested with an ohmmeter. The ohmmeter is used to check continuity between the pin terminals.
Switch Circuit Identification
- Terminals 1 and 2: brake lamp circuit
- Terminals 3 and 4: RWAL/ABS module and Powertrain Control Module (PCM) circuit
- Terminals 5 and 6: speed control circuit
Switch Continuity Test
NOTE: Disconnect switch harness before testing switch continuity.
With switch plunger extended, attach test leads to pins 1 and 2. Replace switch if meter indicates no continuity.
With switch plunger retracted, attach test leads to pins 3 and 4. Replace switch if meter indicates no continuity.
With switch plunger retracted, attach test leads to pins 5 and 6. Replace switch if meter indicates no continuity.
SOURCE: 2001 dodge ram 1500. Brake lights do not work.
Do the taillights work? If so it might just be the bulb. If not then the wiring is broke some where or loose.
27 views
Usually answered in minutes!
×