Question about Chevrolet Cars & Trucks

Open Question

2006 chevrolet cobalt engine code po455 - Chevrolet Cars & Trucks

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 137 Answers

SOURCE: how do I replace my 2006 Chevrolet Cobalt Brakes

first loosen the road wheel nuts. then jack it up. then remove the road wheel. then turn the wheel out (brake side) get a g clamp put one end on the caliber and the other on the outside pad and wind nice and slowly then remove the two bolts holding the caliber and put aside DONOT TOUCH THE BLEEDING NIPPLE OR REMOVE ANY OF THE RUBBER HOSES ON THE BRAKE LINES open the reserveor (BRAKE FLUID CAP) the disk (rotor) look for a retaing screw on it and remove it some cars havem some dont then tap the disk off asemably is the reverse of removel

Posted on Jul 08, 2009

  • 245 Answers

SOURCE: My car has these codes

CODE O141 IS AN O2 SENSOR WHICH IS NOT WORKING
CODE P0300 IS A RANDOM MULTIPLE MISFIRE WHICH IS IN RELATION TO THE FIRST CODE
CODE PO455 IS THE EVAP PURGE CONTROL VALVE WHICH IS SHORTED (NOT WORKING)

Posted on Jan 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2006 chevy equinox code po455 I change the fuel cap and the purge evap valve but my code comes back what else could it be?


As you know one of the problems can be the Fuel Cap. I make this suggestion. If you changed your Fuel Cap before the Purge Valve double check that the cap used was an OEM (Original) Chevy Part for that specific vehicle, not just any cap from another Chevy.

Feb 28, 2015 | 2006 Chevrolet Equinox

1 Answer

2006 Cobalt 2.2 litre has check engine light come on, then "engine disabled"


That code dsoesn't 100% mean the sensor is defective, other factors can set it. See list below.
Possible causes- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty Camshaft Position Sensor
- Faulty starter motor
- Starting system circuit
- Dead (Weak) battery
P0601 CHEVROLET - Power Control Module Internal Fault

Cause: Faulty PCM. (Powertrain control module)

Jun 14, 2012 | 2006 Chevrolet Cobalt

2 Answers

2006 cobalt ss 2.4 automatic trans. check engine light code p0010 p0106


Code P0010 Intake camshaft position actuator solenoid control circuit ( CMP )

most common cause is a bad solenoid, but it could be many componets that could cause the code, if you want to try to repair it on your own the only thing you can do is replace the solenoid, all other componets require some speclized test equipment.

code P0106 manafold absolute pressure sensor ( MAP )

check for a good vacuum source to the MAP sensor if there is a good vaccum source then replace the sensor.

good luck

Oct 19, 2011 | 2006 Chevrolet Cobalt

1 Answer

Need to change the knock sensor on a 2006 chev cobalt will i need to take off starter


There are 3 different engines available for 2006 Chevrolet Cobalt. [ L4-2.4L VIN B, L4-2.2L VIN F, L4-2.0L SC VIN P ] You will probably get a much more accurate answer to your question if you would take the time to mention WHICH of these engines your vehicle is equipped with.

Aug 05, 2011 | 2006 Chevrolet Cobalt

1 Answer

The Code PO455 is coming up on my 2006 Chevrolet Cobalt 2.2 4 cycl engine. Any ideas what this is?


P0455 Evaporative Emission Control System Leak Detected (large leak check your gas cap make sure its tight , check the EVAP system for cracked or disconnected hoses,, once you remove and put the gas cap back,, clear the code and wait a couple of days ,, you should be fine

Jun 13, 2011 | Chevrolet Cobalt Cars & Trucks

1 Answer

2006 cobalt, Engine stalls after driving awhile when you slow down to stop or turn a corner. No codes in computer - checked.


could be alot of things does it start shaking /missing or is it just a hard **** when it does it

Jan 26, 2011 | 2006 Chevrolet Cobalt

1 Answer

My car has these codes coming up. What are they? PO141 PO455 PO128 PO300... My car is a 2006 Chevrolet Cobalt


CODE O141 IS AN O2 SENSOR WHICH IS NOT WORKING
CODE P0300 IS A RANDOM MULTIPLE MISFIRE WHICH IS IN RELATION TO THE FIRST CODE
CODE PO455 IS THE EVAP PURGE CONTROL VALVE WHICH IS SHORTED (NOT WORKING)

Jan 12, 2011 | 2006 Chevrolet Cobalt

1 Answer

Idols rough, engine light on, code said it could be a vacuum hose. Can not find vacuum hose. Where is it located. 2006 chevy cobalt 2.2l


codes cant say anything, and they really cant say theres a hose off. codes only tell what the computer is seeing that it doesnt like.

Dec 06, 2010 | 2006 Chevrolet Cobalt

1 Answer

Engine light stays on 2006 chevy cobalt 4cyl.


you have to get the code read. go to any shop or buy a hand held reader to reset/ find the code.

Jul 13, 2010 | 2006 Chevrolet Cobalt

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...