Don't know how to use 4WD on 1995 jeep cherokee

Anonymous Dec 21, 2008

You are a lifesaver! I can't thank you enough! Very helpful and right on info!

1 Answer

Anonymous

Contributor 6 Answers
Posted on Dec 21, 2008

Anonymous

Contributor

Joined: Dec 21, 2008

Answers

Questions

Helped

1798

Points

The jeep cherokee has 2 different types of 4 wd systems. the command trac has 2 wd, 4hi, neutral and 4 low. if driving on pavement make sure it's in 2 wd. it also has shift on the fly, up to 60 mph you can move the lever to 4 hi and it will not hurt anything. if trying to go to 4 low, be rolling less than 5mph and put the trans shifter in neutral and move the 4wd selector to 4 low. do the reverse to move back to 4 hi or 2 wd

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

1995 Jeep Cherokee stuck in 4WD goes into 4 wheel but doesn't want to come out

This is not a great thing at all. The 95 uses the same system as mine , which is a linkage that controls the transfer case. You have to get under the vehicle and check that linkage. It may have come loose and now the lever will not pull it out of 4wd.

Read full answer

Nov 06, 2013 • 1995 Jeep Cherokee

0helpful

1answer

What gear should i drive my all 4wd 1995 jeep cherokee in on dry roads with a speed of 70mph??

if its all wheel drive and you cant take it out of fourwheel drive then it was set up from the factory like that and is fine. if you can take out of fourwheel drive then you should.

Read full answer

Dec 15, 2012 • 1995 Jeep Grand Cherokee

0helpful

1answer

I have a 1994 4wd grand cherokee jeep what makes it bump at sharp turn's

Sounds like the front axle in engaged,if it is command trac there may be a problem with the vacuum "motor" on the front axle.

Read full answer

May 21, 2012 • 1995 Jeep Grand Cherokee

0helpful

1answer

I have a 1995 Jeep Grand Cherokee Laredo, 4.0 engine automatic 4WD, my transmission began slipping and not wanting to shift into drive or overdrive. I added a bottle of Lucas Transmission Fix and it began...

drop the pan and change the filter and gasket, that might buy you some time if it is not too far gone.
i don't know how many quarts of transmission fluid are required for this task but the part store should have it in their computer

Read full answer

Sep 29, 2011 • 1995 Jeep Grand Cherokee

0helpful

1answer

How to put a 95 or 96 jeep cherokee sport in 4 wheel drive. handle is left of the gear shift.

You can change on the run but as a general rule stop to change to 4wd.except 2wd to 4wd high.Just slow down to about 15mph and back off the gas.
2wd high is normal running
4wd high(is full time 4wd)this is slippery roads or muddy roads.
4wd high lock For bad and slower slippery and rocky roads.
4wd low lock is for extreme 4wd conditions
Don't use the last 2 on the main roads or transfercase will be damaged
Hope this helps

Read full answer

Dec 03, 2010 • 1995 Jeep Cherokee

0helpful

1answer

1995 jeep cherokee sport 4.0L. Oil gauge keeps sending false message ie. jumps from almost center past the highest point on the gauge. How do I fix this problem? where is the gauge sender located?

OIL PRESSURE SWITCH-I'm not sure if this is the gauge sender, though. 1995 Jeep Grand Cherokee 4WD 4.0L MFI 6cyl The Oil Pressure Switch is located: Under hood, passenger side, lower engine area, above oil pan, mounted in engine block.

Read full answer

Nov 01, 2010 • 1995 Jeep Cherokee

1helpful

1answer