How can I fix the driver side seatbelt which is stuck and wont come out? Do I have to replace it of is there any quick fix?
SOURCE: my drivers side automatic seatbelt is stuck on the
Open small plastic access panel located between front and rear doors a few inches above floor. Disconnect the two wire connector (usually attached to car frame) and locate the male pin connector, usually 1 red and 1 blue wires. Run two long wires from a car battery neg. post and pos. post (battery on the car or separate.) Hold one wire against one pin of the connector and quickly touch the other wire against the remaining pin. This will cause the motor to turn in one direction. If motor turns in wrong direction simply reverse the wires until motor brings belt to desired position then quickly remove the wires. Reattach connectors to resume 'normal' operation after 'CAUSE' has been repaired.
SOURCE: The seatbelt is stuck/jammed in
Hi,
If you can remove the inner door panel you will see a maze of cables running to the various locking points on the sliding door. The front cable is short, and easily replaced.
Please check the bellow link and follow the discussion there to have a view rgarding your problem….
http://www.toyotaownersclub.com/forums/index.php?showtopic=29201
Let us know if you have somethin more to ask else accept the suggestion.
Thank You for contacting Fixya
839 views
Usually answered in minutes!
×