- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
timing belt changes across the board are 60.000miles or 100.00klms. If there are oil leaks inside the plastic cover or the area of operation is dusty reduce that distance by 15%
turn over or run
turning over is cranking but not starting/running
not turning over indicates seized motor , bad battery starter motor problems , bad ground
turning over is cranking but not starting ---broken timing belt/chain, crank/cam position sensors , no fuel , no spark , no injector operation
best run the fault codes as the fauty will be recorded there
heres a diagram to help you, loosen the bottom bolt a few turns then loosen the top bolt then loosen adjusting bolt to loosen belt, use the adjuster to tighten the new belt then tighten top and bottom bolts, hope this helps,
you'd be better off putting a Hub asy on the Compressor.Just because the compressor is locked up doesn't mean the Hub Bearing will not turn freely on the Clutch asy, just leave the wires to compressor disconnected from the Hub/clutch asy, the belt will ride fine , on a bad compressor, as long as it isn't engaged
change the control modul. that control voltage to the coils. it sound like it not bleeding off fast enough the control modul is under the coils. befoe changing any part remove ground off battery. befor change any coils u could of swop to see if this is still not firing
×