20 Most Recent
1998 Mazda Protege Questions & Answers
What does the ST. SIGN 10A on the fuse diagram
Hello mrmp1975: My name is Roger and I will answer your question. ST.Sign stands for starter signal. This fuse should control the starter relay off of the ignition switch. Should you need further help please just ask. Please rate the answer as this way I know it was helpful. Thank You for using Fix Ya. Roger
The main panel of lights on the rear of my 98
I have same problem and have found the lower light to have a malfunction in the socket. Mazda says replace brake harness. Cheap fix junk yard but same prob can come back. Also does your cruise work? may be related to switch on brake pedal.
1998 Mazda Protege: 1.8l. Getting code cyl #3 misfire. New wires, new distributor and new plugs. Ideas?
Indeed, it could be a bad injector causing the "dead" cylinder. Have someone remove the actuator wires connected to the injectors and do an ohm-meter test on them to see is that #3 injector the only one showing a different value from the rest. If so, you need change the injector. The injector itself is cheap enough, just getting it changed can cost a little. I don't know what that price would be. Now, IF all injectors read out the same or close in values, Then it's apparent you need to have a compression check done on all cylinders. If you find #3 cylinder compression is very low, then you need have a valve job done on that head. Most likely the exhaust valve is burnt/faulty. I'm not looking to scare you, I'm just telling you what needs done and how simple or complex this "miss" can possibly be caused by.
My clutch isn't working
The thing does wear out. Try adjusting it first. If that doesn't work replace the whole clutch and if the flywheel has any hard spots on it, have them removed first or the new clutch will wear quickly
Blower motor not working on 4 1998 Mazda protege
check for power and ground at the blower motor. if this is good then hit motor. if it starts the motor needs replacing. then check the fuse then the fan speed switch for power and ground going to the switch and coming out of switch.
No brake lights
Sounds like it is your brake light switch which is located on the brake pedal itself. Should cost around $20 at autozone and is pretty easy to change out yourself. Thanks for rating my response and for using FixYa!
My 1998 Mazda protege is stuck in park? Help me fix please
the release is a solenoid that is powered by applying the brakes. do you have brake lights. that gives you an indication that the signal is being generated and that the solenoid is either bad or miss adjusted. this device is within the shifter console.
Not finding what you are looking for?