Transmission Range Sensor 1994 PARK AVE

SOURCE: 91 buick park ave.

Well, that can be a ton of things. Usually it means: A. its not getting enough air, or any air. B. Its not getting enough gas. It could be a problem with the Mass flow Sensor- which can be cleaned or replaced-, or maybe a bad fuel pump or bad fuel lines or something. Either way the problem sounds like it just can't run because it can't get enough gas.

Greg Bernett

• 2993 Answers
• Posted on Jun 23, 2009

SOURCE: try to locate body control module on a 94 buick park ave

BCM --The Body Control Module is located on the right side of the vehicle and positioned under the instrument panel. In order to gain access to the module, it will be necessary to first remove the trim panel.

SOURCE: replace 2000 buick park ave serpentine belt

Firt - study & write down (draw) the belt path,,
and be sure about it..

Then - put a wrench on the nut in the center of the tension pully.. Move the tension pully to loosen the belt.. Pull belt off..

Repeat to put new one on..

Should be pretty easy..

honeymokey

• 3113 Answers
• Posted on Jul 20, 2009

SOURCE: 1991 buick park ave. security system set off,

Did you try the drivers door lock cylinder?

SOURCE: 1994 buick park ave, wont crank over,

Pass key is the security system which disables the car if it is stolen. You need the remote or a key with a chip to start the car. go to a dealer, prove ownership with registration and they will be able to help you out