Still has codes p1323 p1350 p0135

P0101
Mass or Volume Air Flow Circuit Range/Performance Problem
P0102
Mass or Volume Air Flow Circuit Low Input
P0135
O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1

Your O2 sensor needs replacing...do this then disconnect negative battery ground, wait 10 minutes and reconnect. If all cleared, use a scan tool and clear properly, these are relatively cheap or take it to a shop.

O2 sensor heater circuit malfunctioning Bank 1 sensor 1 . May be a corroded connection or blown fuse .

Does engine stumble and idle too low and die? This can be tune up issues, dirty idle air motor, dirty or sticking EGR, bad coolant temp sensor, clogged cat converter or muffler, bad O2 sensor, weak coil of bad ignition module, and more! You need diagnostic tests and readings.

The powertrain control module (PCM) doesn't like the information it is getting from the ignition control module (ICM), and the PCM controls shifting, traction control, etc.If these are the only codes you are getting and the car moves, then you could assume the sensors connected to the ICM are working properly. That leaves why the PCM thinks there is a problem. I would certainly replace the ICM first, and then if the problem still exists, the PCM.

How to Diagnose a P0135 -Heater
Performance Bank 1 Sensor 1 (GM 3.5L) January 31, 2012 Updated: October 29, 2014 Written by: Abraham Torres-Arredondo Article Id: 371

• Page 1
• Page 2
• Page 3
• Page 4

If your check engine light is on and you have a diagnostic trouble code P0135 stored in the PCM's memory... then you've come to the right place to test and troubleshoot the upstream oxygen sensor.
A P0135 DTC says: HO2S Heater Performance Bank 1 Sensor 1... and this means that the PCM (Powertrain Control Module = Fuel Injection Computer) has detected a problem with the front oxygen sensor's heater element or a problem in the heater's circuit (wires).
In this tutorial, I'll show you how to check the oxygen (O2) sensor's heater element and the two circuits that feed it with power (10 to 12 Volts) and ground with a multimeter.
In case you're wondering, where the oxygen (O2) sensor that the code P0135 is accusing of being BAD is... this bad boy is located on the exhaust manifold and before the catalytic converter.
To help you navigate this article, here are its main points:

1. Symptoms of a BAD Oxygen Sensor Heater Element.
2. What Tools Do I Need to Test Code P0135?
3. What Does the Heater Inside the Oxygen Sensor Do?
4. Circuit Descriptions of the Downstream Oxygen Sensor.
5. Start Here.
6. TEST 1: Oxygen Sensor Bank 1 Sensor 1 Test.
7. TEST 2: Checking 12 Volts to O2 Heater.
8. TEST 3: Checking the O2 Heater's Ground Circuit.
9. TEST 4: Ohming the O2 Heater Element.
10. P0135 O2 Sensor Heater Test Summary.

Buying a Digital Multimeter for Automotive Diagnostic Testing (found at: easyautodiagnostics.com).

Scan Tool.

1. Don't have one?... check out my recommendation: Abe's Scan Tool Recommendation.

Wire Piercing Probe.

1. Although this tool is not an absolute must, if you do buy one, you'll realize just how easy it makes testing the voltages inside the wires.
2. If you need to see what this tool looks like, you can see it here:Wire Piercing Probe.

< Prev

1

2

3

4

Next >

Applies To:

Buick Vehicles:

• Rainier 4.2L
  • 2004, 2005

Chevrolet Vehicles:

• Colorado 3.5L
  • 2004, 2005
• Trailblazer
  • 2004, 2005

3.5L
How To Test for a Blown Head Gasket (GM 3.5L, 4.2L)
How to Test the MAF Sensor and Codes: P0100, P0101, P0102, P0103
How To Test for a Blown Head Gasket (GM 3.5L -FWD)
All Articles: 3.5L "A day without sunshine is like, you know, night"
Steve Martin
MORE TUTORIALS:

P0134 - O2 Sensor Circuit No Activity Detected Sensor 1 Bank 1
P0135 - O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1
P0053 - O2 Heater Resistance Bank 1 Sensor 1
P0030 - O2 Heater Control Circuit Bank 1 Sensor 1
You need to replace the O2 Sensor Bank 1 Sensor 1
Carquest can help you get the correct part and help you locate it.

The fault code P0135 means O2 Sensor Heater Circuit (Bank 1 Sensor 1)
The code P0141 means O2 Sensor Heater Circuit (Bank 1 Sensor 2)

Launch X431 Connector

P0135 bank 1 sensor 1 open or short in wires,bad connections,bad sensor ,or bad ecm. P0141 bank 1 sensor 2 same diag as P0135. P0420 cat below threshold open or short, or faulty Ho2s sensors.you may have several problems. start with sensors circuit if good change sensors if not trace to ecm if reading not right replace ecm if all good replace sensors clear codes retest drive two drive cycles for cat to clear tests. then with no dtcs present test fuel pressure , injectors,then ignition system ,timing valves ,map,maf sensors,throttle sensor,crank sensor cam sensor, compression.

P0302 TOYOTA - Cylinder 2 Misfire Detectedhttp://engine-codes.com/p0302_toyota.htmlForum CodePossible causes- Faulty spark plug 2
- Faulty ignition coil 2
- Ignition coil 2 harness is open or shorted
- Ignition coil 2 poor electrical connection
- Clogged or faulty fuel injector 2
- Injector 2 harness is open or shorted
- Injector 2 poor electrical connection
- Improper spark plug 2
- Insufficient cylinder 2 compression
- Incorrect fuel pressure
- Intake air leak
P0135 - O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1http://engine-codes.com/p0135.htmlForum CodePossible causes- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit open shorted to ground
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit poor electrical connection
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit fuse
- Faulty Engine Control Module (ECM)
Tech notes The code means that there is a problem with the heater element circuit of the heated oxygen sensor. The Engine Control Module (ECM) monitors how long it take the sensor to warm up and start sending an adequate signal. The code means the the sensor is taking too long to warm up. Replacing the O2 Sensor 1 usually takes care of the problem
P1705 TOYOTA - Direct Clutch Speed Sensor Circuit Fault.
This is related to the sensor that gives info about the slippage rate o fthe transmisssion to the Transmission Control Module..

there are over 200 reasons for the check engine light to come on, the gas tank cap is just one of them, this light and the problem that turned it on are most likely covered under the federal emission warranty, contact the dealer. see trouble code list below for some of the probelems that cause a check enghine light.
P1100 Map Sensor - Malfunction
P1101 Map Sensor - Abnormal
P1102 Map Sensor - Low Input
P1103 Map Sensor - High Input
P1104 Air Flow
P1105 Air Flow - Abnormal
P1106 Air Flow - Low Input
P1107 Air Flow - High Input
P1108 Fuel Pump
P1109 Fuel Pump - Abnormal
P1110 Fuel Pump - Stuck On
P1110 ETS System - Malfunction
P1111 Fuel Pump - Electrical
P1112 Manifold Differential Pressure Sensor
P1112 VGT Actuator - Malfunction
P1113 Manifold Differential Pressure Sensor - Abnormal
P1114 Manifold Differential Pressure Sensor - Low
P1115 Coolant Temperature Input - Abnormal
P1116 Boost Pressure Sensor - Malfunction
P1118 ETS Motor - Malfunction
P1119 Inlet Metering Valve Control
P1120 Electric Governor - Malfunction
P1120 Inlet Metering Valve Malfunction
P1121 APS PWM Output Circuit Malfunction
P1121 Throttle Position Input - Abnormal
P1122 Boost Pressure Control Valve
P1123 Fuel System Rich - Idle
P1123 Timer Position Sensor - Malfunction
P1124 Fuel System Lean - Idle
P1125 Fuel Press Sensor1
P1126 Fuel Press Sensor2
P1127 Fuel System Rich - Part Load
P1127 Control Sleeve Position Sensor
P1128 Fuel System Lean - Part Load
P1130 Start Solenoid- Malfunction
P1131 Injection Quantity Adjust
P1134 O2s Transition Time(B1/S1)
P1135 Injection Timing Servo
P1140 Inlet Air Temperature Sensor Malfunction
P1141 Slow Duty Solenoid- Malfunction
P1145 Main Duty Solenoid- Malfunction
P1146 Idle Co Potentiometer
P1147 Accelerator Position Sensor (ETS) Circuit
P1150 Barometric Pressure Sensor Malfunction
P1151 Accelerator Position Sensor (EMS) Circuit
P1152 Accelerator Position Circuit-Low Input
P1153 Accelerator Position Circuit-High Input
P1154 O2s Transition Time(B2/S1)
P1155 Limp Home Valve- Malfunction
P1159 Variable Induction System
P1162 High Pressure Pump & Fuel Line
P1166 O2s (B1) Control Adaptation
P1166 Limit O2s Lambda Control (B1)
P1167 O2s (B2) Control Adaptation
P1167 Limit O2s Lambda Control (B2)
P1168 O2s (B1/S2) Heater Power
P1169 O2s (B2/S2) Heater Power
P1170 ECM (Barometric Pressure Sensor)
P1171 ETS Valve Stuck - Open
P1172 ETS Improper Motor Current
P1173 ETS Target Following Malfunction
P1174 ETS Valve Stuck - Close #1
P1175 ETS Valve Stuck - Close #2
P1176 ETS Motor Open/Short #1
P1177 ETS Motor Open/Short #2
P1178 ETS Motor Power - Open
P1179 ETS Position F/B-Mismatch
P1180 O2 S1 Heater Circuit- Malfunction
P1180 Fuel Pressure Regulator - Malfunction
P1181 Fuel Pressure Monitoring
P1182 O2 S2 Heater Circuit - Malfunction
P1182 Fuel Pressure Regulator - Short
P1183 Fuel Pressure Regulator - Open
P1184 O2s No Activity (B1/S2)
P1184 Fuel Pressure Regulator - Power
P1185 Fuel Position - Excessive
P1186 Fuel Pressure - Too Low
P1187 Regulator Valve - Stuck
P1188 Fuel Pressure - Leakage
P1189 Governor Deviation
P1190 Intake Throttle Actuator
P1191 ETS Limp Home Valve On
P1192 Limp home - Target Follow Malfunction
P1193 ETS Limp Home - Low Rpm
P1194 Limp Home - TPS2 Position Malfunction
P1195 Limp Home - Target Follow Delay
P1196 ETS Limp Home - Close Stuck
P1300 Spark Timing Adjust Signal
P1300 Injector Specific Data Fault
P1300 Synchronization Error-CKP/CMP
P1301 TDC Sensor - Abnormal
P1302 TDC Sensor - Low Input
P1303 TDC Sensor - High Input
P1304 Phase Sensor
P1305 Phase Sensor - Abnormal
P1306 Phase Sensor - Low Input
P1307 Phase Sensor - High Input
P1307 Accelerator Sensor - Range/Performance
P1308 Ignition Coil.1
P1308 Accelerator Sensor - Low
P1308 Accelerator Sensor Circuit - Low
P1309 Ignition Coil.1 - Abnormal
P1309 Accelerator Sensor - High
P1309 Accelerator Sensor Circuit - High
P1310 Ignition Coil.1 - Low Output
P1310 Injection Control Circuit Fault
P1311 Ignition Coil.1 - High Output
P1312 Ignition Coil.2
P1313 Ignition Coil.2 - Abnormal
P1314 Ignition Coil.2 - Low Output
P1315 Ignition Coil.2 - High Output
P1316 Ignition Coil.3
P1317 Ignition Coil.3 - Abnormal
P1318 Ignition Coil.3 - Low Output
P1319 Ignition Coil.3 - High Output
P1320 Ignition Coil.4
P1321 Ignition Coil.4 - Abnormal
P1321 Glow Indicator Lamp - Short
P1322 Ignition Coil.4 - Low Output
P1322 Glow Indicator Lamp - Open
P1323 Ignition Coil.4 - High Output
P1324 Glow Relay - Malfunction
P1325 Glow Relay - Abnormal
P1325 Glow Relay
P1326 Glow Relay - Stuck On
P1326 Glow Relay - Short
P1327 Glow Relay - Electrical
P1327 Glow Relay - Open
P1330 Spark Timing Adjust Signal
P1331 #1 MF Signal Line Short
P1332 #2 MF Signal Line Short
P1333 #3 MF Signal Line Short
P1334 #4 MF Signal Line Short
P1335 #5 MF Signal Line Short
P1336 #6 MF Signal Line Short
P1337 #7 MF Signal Line Short
P1338 #8 MF Signal Line Short
P1340 IFS 2 Open