jay rotary posted an answer for this Mazda Cars & Trucks:
"The 13B EFI engine has pressure activated secondaries on the lower manifold. If you have a..."
jay rotary posted an answer for this 1993 Mazda RX-7:
"Stan is correct, plus you can not use any thermostat. It has to be one that is specific to..."
jay rotary posted an answer for this 1983 Mazda RX-7:
"Recommend you download the FSM and wiring diagram from http://foxed.ca."
jay rotary posted an answer for this 1985 Mazda RX-7:
"The 13B EFI engine has pressure activated secondaries. If you have a 'free flowing..."
jay rotary posted an answer for this 1988 Mazda RX-7:
"You can download a FSM and wiring diagram from http://foxed.ca."
jay rotary posted an answer for this AC Cars & Trucks:
"I would recommend you download the FSM and electrical manual from foxed.ca. Not foxed,com..."
jay rotary posted an answer for this 1991 Mazda RX-7:
"How many miles on engine?. What color smoke? If white clouds of smoke that goes away when..."
jay rotary posted an answer for this 1984 Mazda RX-7:
"go to foxed.ca. You can download the Mazda Factory Service Manual. Much better than any..."
jay rotary posted an answer for this 1984 Mazda RX-7:
"check the vent valve left center air horn, just under the fill tubes, As long as the fuel..."
jay rotary posted an answer for this 1984 Mazda RX-7:
"yes it will bolt on. emissions will be an issue. The Nikki carb is pretty bullet proof and..."
jay rotary posted an answer for this 1985 Mazda RX-7:
"leading 1, trailing 1, leading 2 trailing 2. leading timing mark is first mark on damper,..."
jay rotary posted an answer for this 1985 Mazda RX-7:
"Problems with flashers and turn signals are common with the 1st gen 7 now. Contacts are..."
jay rotary posted an answer for this 1985 Mazda RX-7:
"No such thing. There are trailing and leading ignitors which are on the distributer. ..."
jay rotary posted an answer for this 1985 Mazda RX-7:
"check alternator and charging system."
jay rotary posted an answer for this 1985 Mazda RX-7:
"check fuses, ignition switch and ignitors. Ignitors are common failures especially if you..."
jay rotary posted an answer for this 1985 Mazda RX-7:
"Did you use a Mazda/Mitsubishi cap and rotor. Many of the aftermarkets can cause problems,..."
jay rotary posted an answer for this 1985 Mazda RX-7:
"you could have either a bad water temp sensor or bad choke switch."
jay rotary posted an answer for this 1985 Mazda RX-7:
"check fuses and dimmer switch."
jay rotary posted an answer for this 1986 Mazda RX-7:
"No easy way. It is a pain job. Correct size wrenches most important. No adjustables. Fan..."
jay rotary posted an answer for this Mazda Cars & Trucks:
"outside, forward of tank left of center"
jay rotary posted an answer for this 1983 Mazda RX-7:
"just need a good axle puller, I have almost always gotten them out with an old axle and..."
jay rotary posted an answer for this 1986 Mazda RX-7:
"Need to make sure it is turning fast enough, and cranking voltage does not go below 10V. ..."
jay rotary posted an answer for this 1988 Mazda RX-7:
"Check all fuses and connectors. wiring diagram can be found at http://foxed.ca/"
jay rotary posted an answer for this 1984 Mazda RX-7:
"Checked grounds? remove all connectors and clean them. Make sure you have 12V coming from..."
jay rotary posted an answer for this 1988 Mazda RX-7:
"The FC3S is notorious for this and fueling issues. Check all ground points, battery cables..."
jay rotary posted an answer for this 1988 Mazda RX-7:
"Best parts are Mazda. cheap parts are cheap. No quality part is going to be low price. If..."
jay rotary posted an answer for this 1985 Mazda RX-7:
"You set the leading timing with the distributer. You then set the trailing timing with the..."
jay rotary posted an answer for this Mazda Cars & Trucks:
"Year, Model?. factory wiring diagrams can be found at http://foxed.ca/"
jay rotary posted an answer for this 1993 Mazda RX-7:
"Afraid you probably have engine issues. White smoke was water. clanking could have been..."
jay rotary posted an answer for this Mazda Cars & Trucks:
"Too many things it could be with a burn car. It is very hard to give a proper diagnostic..."
jay rotary posted an answer for this Mazda Cars & Trucks:
"left side above clutch pedal, or left foot if automatic. Shown in owners manual exactly."