Jabsco Recent Questions, Troubleshooting Help & Support

http://media.channelblade.com/EProWebsiteMedia/3506/Jabsco%20Twist%20n%20Lock%20Manual%20Toilets.pdf the above is the link to the operators and installation manual see pages 3 and 4 this tells you how to install the inlet pipe so just reverse for removal

Check the power source to toilet and all wiring conversed.

Google it for a diagram. Usually the impeller can be drawn out with two screwdrivers on opposite sides. The seal should be deeper in there, unless it fits from the motor side. Don't forget the gasket, and lube the impeller with something compatible with your system for startup.

Newark Electronics, DigiKey Electronics, etc

Multiply all three numbers together and you have your answer in cubic m.

Most of those clutches are not adjustable and the pumps can be adjusted by putting a thinner gasket on the back cover just make sure the pump still tuns easy.

The leak could be in the pump itself. How is the rest of the pump, is it worn. If everything is OK then you have a leak in the suction side.

Try this link, I am not sure if they have it. http://www.pumpvendor.com/Jabsco_6050-0003_parts.html

check the fresh water feed tank to the toilet is connected correctly and is that tank steel as it could be rusty ! ??

where you press the pedel at the base of the loo the rotating valve has a seal , check for trapped dirt or damaged seal ! good hunting and wear gloves ! lol

How to Size Pressure Tank PAR Max Plus Series If the maximum pressure is set at 30-50 psi , a 20 gallon (minimum) will work. Residential Tank Sizing Calculator

Was the toilet "Winterized" last fall? If so, have you assured that any plug in the clean water intake has been removed? If NOT -- are you sure the pump has not been frozen and internally damaged by ice? The pump is a simple device which rarely fail unless its inlet is blocked, or the pump seals or body are damaged - usually by freezing.