Question about 2008 Ram 3500
...Pulley (3) Power Steering Pump Pulley (4) Radiator Fan Pulley (5) Crankshaft Pulley (6) Automatic Tensioner (7) A/C Compressor Pump Pulley (8) CAUTION: When installing the accessory drive belt, the ...
need a diagram for fan belt or serpentine belt Here is a diagram for a 5.7L Hemi, and 1 for a 5.9L diesel. Hope this helps! 5,7L HEMI 5.9L Diesel Part of the problem in replacing the serpentine belt ...
...tension arm the pulley is bolted to you will see a square hole that is the size of a 1/2" drive socket wrench. Get a 1/2" socket/breaker bar and put the square peg in the hole and then pulling the ...
tools and some help is available how do you replace it? IT SHOULD BE SERPITINE BELT . SHOULD HAVE A TENSIONER PUT BELT AROUND PULLEYS THEN PULL UP ON TENSIONER TO GET BELT ON . JUST A WRENCH OR SOCKET
...tension pulley that you will need to turn to have enough slack to get the belt on, this pulley is about 3 inches in diameter, get a 1/2 inch ratchet and put a short extension on it, in the center of ...
...4 over the power steering pulley 5 over radiator fan pulley 6 over crankshaft pulley 7 automatic tensioner 8 over a/c if ...
...Going to assume it is a 5.9 cummins. Use a 3/8 or 1/2 inch drive ratchet in the hole on the belt tensioner to push or pull the tensioner away from the belt. You'll have to run the new belt ...
Usually answered in minutes!
111 Questions
242 Questions
241 Questions
152 Questions
127 Questions