Question about POLARIS 380 HEAD/HOSE INGROUND POOL CLEANER -
...water? Are your hoses tangling? Is main circulation pump on? It needs to be, for your 380 sweep to work If it is sluggish to barely moving, then do the easy thing - if you haven't as of
Question about BARRACUDA G3 IN-GRND CLEANER
I have a Sta-Rite Max-E-Glas II (1.5hp) Pool pump and a Hayward Navigator sweep. The sweep was working then stopped. Pulled it apart found bad bearings replaced them. Ran sweep again worked at first ...
Question about Baracuda G3 Automatic In Ground Pool Cleaner
no movement with my g3 baracuda I have suction, but no movement, when I place my hand over the mouth it creates the pulsating movement until my hand is removed, then back to suction only, no movement ...
Question about Baracuda Zippy Pool Cleaner
The barracuda just returns to the deep end of the pool and stays there, how can I get the cuda to sweep the whole pool? The Barracuda Zippy is an Above Ground pool cleaner and is not designed for a ...
Question about POLARIS 380 HEAD/HOSE INGROUND POOL CLEANER -
...at the wall is significant. Also the Propulsion knob at the rear of the unit just above the sweep hose is set at 11:00 Position. The Pool ...
I have replaced the diaphragm on my Classic. I have even replaced the filter sand. There are no apparent tears in the pipes, yet the cleaner runs for a few minutes and then stops dead, not pulsating. ...
Question about Baracuda G4 Automatic Pool Cleaner Ne221
...hand over the end of the hose. Suction hose may also have an obstruction which will inhibit proper operation. Mine also will run very slowly for a little while, then stop. Seems like total blockage ...
My pool cleaner only sweeps the deep water zone. It never comes up to the shallow half part of the pool. By the way, the approximate size of my pool is 18 ft x 36 ft. This should be an easy problem to
syncronize second hand will not line up to zero pull crown out to second position then press start button till it goes to 0 then push crown back in..
Question about Baracuda Zippy Pool Cleaner
my pool sweep stays in the deep end and will not move to the shallow end of the pool make sure you have proper flow rate and try shortening the length of the vac hose. this will change the pattern the
Usually answered in minutes!
101 Questions
90 Questions
97 Questions
48 Questions
31 Questions