magnum 257 thanx mechanic i only use ssb so do you think this info should do the trick? colin Yes, there is info there to do a complete alignment for the transmitter or receiver. I do have to wonder ...
magnum S9 10/11 mtr radio i have a magnum s9 radio. the receive on FM mode has drifted, eg: i normally talk to friends on ch 31., freq 27.315. they all can hear me ok on this freq according to my freq
bay they have replacement switchs real cheap,5-10 dollars.they are also easy to change with minamal soldering skills
Hi! I have had Magnum S-9 for about 4 years. Recently when i key-up and talk for 30 seconds or more it will start to brake up, not sure if it's bad microphone or an internal problem. Thanks! Just ...
...will need to be unscrewed from the chasis to do it. It isn't too tough to do with good eyesight, soldering skills, and a steady hand. total night mare and some are impossible to access unless ...
My magnum 257 was bought second hand on eBay it works fine on all modes but has no modulation it does tx and rx fine on both 10 meter band and on the " open" bands **** no voice and I have replaced ...
Stocl mike and behavior linked to temperature Hello, Get another issue with my set, maybe somebody else had experienced that too. The mike picks less and less sound in SSB if the temperature goes ...
...connections when it came to number displays and open resistors. If you are handy with a meter and soldering iron then that will put you ahead of the game. Some radio's use a ribbon cable from the ...
...the Board of your radio. You will need a power supply, a watt meter, dummy load and a 30 to 40 watt soldering gun, solder and solder wick. Chem wick makes the best solder wick. DON'T buy the ...
NEED TO WIRE LESON MICROPHONE TO MAGNUM 257 Notice the black mic plug has the numbers it is solder by numbers. Used rosin core silver solder radio shack sells it.Mic Wiring Stock 1-Shield
Usually answered in minutes!
41 Questions
12 Questions
2 Questions