...typically let you know something changed in how the unit was put into service. Maybe an electrical shortage or power outage caused the unit to trip. Re-set
...heat food ok and the exhaust fan works fine. I would not use the lamps. Sounds like there is a shortage in the wiring for the lamps. They lamps should run together, and if one of the sockets
...and this morning it sounded like it was on but did not heat at all. It smelled like an electical shortage. Is it dead? Probably not dead but the magnatron probably went out and this is the part ...
Question about Spacemaker 1.5 Cu. Ft. Over-the-Range Microwave - CleanSteel
keyboard shortage giving alert to service keypad, has shortage The keypad control board or smart board needs attention," membrane in keypad is shorted"
Question about Spacemaker 1.5 Cu. Ft. Over-the-Range Microwave - CleanSteel
...for a few seconds and stops, the first thing to check is the main control board to ensure that a shortage has not occurred. If the part is defective then it will need to be replaced to prevent ...
...for a few seconds and stops, the first thing to check is the main control board to ensure that a shortage has not occurred. If the part is defective then it will need to be replaced to prevent ...
...for a few seconds and stops, the first thing to check is the main control board to ensure that a shortage has not occurred. If the part is defective then it will need to be replaced to prevent ...
Question about TMS062E1 Microwave Oven
...for a few seconds and stops, the first thing to check is the main control board to ensure that a shortage has not occurred. If the part is defective then it will need to be replaced to prevent ...
Question about TMS062E1 Microwave Oven
...240 for Europe and Canada also check light bulbs inside they could have gotten broken to cause a shortage You have a dead short somewhere either across live and positive, or a short from live to ...
...inverter. Sometimes both. There is not an easy way to test the inverter, the mag can be tested for shortage to ground with an ohm meter and between the terminals to check the filament for
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions