control locked onHe3 Control locked light is on. We unplugged it but the light is still on. It says to press and hold for 3 seconds but that did not work either. Now what do we do to get the wash to ...
...THE START BUTTON JUST BEEPS TWICE try unplugging from wall hold start/power button down for a few sec also ck door ...
...reset thecomputer of my kenmore washer machine if unplugging and holding any button down for a few sec don't work without knowing why you need to "reset" can't help you if unit dead may be several ...
Question about Elite 45986 Front Load Washer
...key (except STOP) and follow the steps below, using the same key (remember the key): Press/hold 4 sec's. Release for 4 sec's. Press/hold 4 sec's. Release for 4 sec's. Press/hold 4 sec's. Release
...test cycle; with unit plugged in, but not in operation, press and hold the rinse button for 4 sec, then release for 4 sec, press for 4 sec, release for 4 sec, press for 4 sec,then all the
control locked is on, how do I unlock? hold in child lock for more than 5 secs....
Question about Elite 45986 Front Load Washer
...step of the WASH cycle. NOTE: To find correct Ohm reading refer to the Water Temperature Sensor section, page 10. Possible Causes/Procedure 1. Unplug washer or disconnect power. 2. Check the
...Means someone put it in controlled lock position. Just hold the Control lock button down for 5 sec or so until the light comes off. Machine isn't
Question about Elite 45986 Front Load Washer
...panel allows you to lock and unlock the controls. find the correct button and hold it down for 5 sec. If this doesn't work unplug it and wait for 5
Question about Elite 45986 Front Load Washer
...it is printed on the control panel. but you have to press and hold a button or 2 for about 5 sec.Hope
Usually answered in minutes!
3,839 Questions
1,023 Questions
0 Questions
69 Questions
45 Questions