Questions & Answers for: Intel what is a roll pin

motherboard i unplugged my power supply, speaker, led display all from the mother board and now my computer won't power on i need a manual for my mother board I unplugged the ' power LED, H.D.D. LED, ...

d815 led and etc pins i have a d815 but i dont know how to hook up the pwr hdd and reset led Looking at page 85 in you're user manual. The 15 pin jumper block. Starting at Pin 1 (Hard drive LED) is ...

bios roll back i have recently updated bios how can i roll back to previous bios i am using intel d102 mother board When you bought you're Intel motherboard it came with a CD with drivers. On that CD ...

nforce4 sli edition audio pins I can't seem to get anything working, speakers or mic, it's either one speaker, or no speakers and the mic. There is a ground pin, a mic pin, 3 ear right pins, and 2 ear

how to connect the led wires in motherboard i have to connect the led (HDD LED, RESTART LED,...) to my motherboard..i have forgotten the place(pin) where i have to connect these led's. motherboard is ...

i am trying to hook up front panel usb ports. I found the pins on the motherboard, but I do not know which wire goes to which pin. I have the number 1 and number 2 wires with 5v, -d, +d, and gnd. ...

Gateway / eMachines 4006149R, D102GGC2 Motherboard connecting the power sw and power led on the Gateway / eMachines 4006149R, D102GGC2 Motherboard Their should be a 9 pin header at the bottom right ...

p4vmm2 can not read sound card after update You can Roll the Driver back... goto the Device Manager and click on the Sound Card and Right Click to get to the Properties Page for the card. Goto drivers

Intel 850MV front panel to motherboard connections Locate J8J1 next to the battery. Pins 9-15 are unused. Pins 12 and 14 are missing. Pins 1 and 3 are for hard drive led. Pins 5 and 7 are for Reset. ...

...without 4 pin ATX pin but not with 4 pin ATx It was working 2 days .Now my motherboard fan is rolling without attaching 4 pin ATX cable but when attached it rolled then stop in seconds ...