...Crank Angle Sensor I need to replace the crank angle sensor on my 1997 GMC Jimmy. I can barely afford the part right now and would like to install it myself. Does anyone have or know of a link to a ...
...crank sensor and the cam sensor is a little more. Any work or repair in there recently? I'd suspect your crank sensor is defective or it's not adjustted correctly. Alot of GMs trucks when they ...
crank sensor located Lower front of engine derictly behind hormonic balancer IE the lower pulley on engine but before the oil pan two wires fairly easy to replace CRANK SHAFT SENSOR LOCATED RIGHT SIDE
...computer, codes read crank sensor, replaced as well, still showing code for crank sensor need more info does it run now yes no if yes did you clear the computer get back to me i hope i can ...
Question about 1998 Jimmy
...crank sensor and it ran for a day, Shut it off and would not start again, replaced sensor again and started. Then the same thing happened again. Now the crank sensor has no voltage supplied to it its ...
Question about 1999 Jimmy
...REPLACING the crank sensor requires a posible adjustment, this deals with your timing, sooooooo, sensor may need adjusted, re-read instructions, this sensor sends info to the ECM, apparently its ...
crank sensor isn't working properly, the engine doesn't know when do do anything. Depending on what the other codes where, I'd highly suspect the CPS. It's not terribly hard to get at nor expensive of
Question about 2000 Jimmy
...replacing crank shaft sensor Probably defective or incorrect sensor, sensor wiring connector problem (bent or corroded pins), improper installation (wrong orientation, not seated properly), etc. Why ...
Question about 2002 Yukon Denali
... What's next? Did you pull a coil an check for spark before replacing the crank sensor ? Does it have fuel pressure ? Are there any lights lit on the SECURITY ? No Start Diagnostic Basics ...
Question about 2002 Yukon Denali
...crank sensor at the front under the front crank pulley and it is in the correct installed position, you should not have a code for that,unless the wiring is defective or the crank sensor is
Usually answered in minutes!
2,225 Questions
1,363 Questions
1,368 Questions
1,418 Questions
1,123 Questions