...Remove the two philips screws holding the switches to the trim piece. 4. Find the two screws holding the arm rest. They're at the junction of the arm rest and the switch assembly. Only the one going ...
...rear view mirror controls and window regulator control switches, if equipped. Remove front door trim panel finish panel. Remove front door trim panel retaining screw through front door trim panel ...
...rear doors a few inches above floor. Disconnect the two wire connector (usually attached to car frame) and locate the male pin connector, usually 1 red and 1 blue wires. Run two long wires from a car ...
...Remove the two screws, and lift the rear of the console finish panel to unsnap retainers. Reach under the console finish panel and disconnect wires to fog lamp and ride control switches (if equipped) ...
...remove the under-dash insulation to access some parts of the fuse panel. If it doesn't have a diagram inside the box, here's one I found online: ...
Usually answered in minutes!
523 Questions
505 Questions
431 Questions
394 Questions
202 Questions