Questions & Answers for: Maytag polarity

my BF250 beverage fountain doesn't have a cord...i tried to buy one, but they need to know the polarity??? Thank you. You need a 110VAC to 12VAC power transformer.  This is an AC transformer; not

...reading at all on the lowest and highest ohm setting on my multimeter both through and reverse polarity. I went on to check the magnetron on the lowest ohm setting at the terminals, again, ...

My maytag washing machine,the start/pause does not turn on the machine. check power and for correct polarity at the machine. check for continuity across the push to start switch while it is pressed ...

witch wires go where? maytag atlantis mde6400ayw the red and black go to terminals marked L1 and L2 polarity isnt an issue here,and the white or bare is the N terminal or neutral connection,if its non

...color wires go where (especially the "hot" red one). RED=RED/BLACK=BLACK(both phase hot wires( NO polarity required) WHITE=NEUTRAL/ GREEN or GREEN/Yellow stripe = SAFETY GROUND to units METAL ...

to if it matters what wire goes to what terminal... The thermostat and the thermal fuse do not have polarity so it does not matter which wire goes to which terminal

Power on but wOnt start drying... has the thermal fuse been checked for polarity .

...answers. I am going to assume a few thing like the electrical cord is properly hooked up and the polarity in not reversed. Because if it is you will continue to have issues with the control board ...

L1/neutral polarity fault+Gibson heating unit swap power input

...Central Control Unit (CCU) and the Motor Control Unit (MCU) has failed. Possible Causes - Reversed polarity or mis-wire along with open ground switch(es). - Communication cable from CCU (MI3) to MCU ...