Questions & Answers for: Behringer point veiw

down on one channel I Have a behringer pmp3000 16 channel mixer amp. the problem i have is that one side is weaker than the other considerably. using the desk in stereo mode. tried and checked leads ...

wires in the microphone at the point where you connect to the lead have come appart and i need to solder them back on, Black, red and white wires. Which in which order do i solder them onto the ...

...2 shorts on SMPSU29. One marked 110V should be removed and the second should be replaced from 110V point to 230V point. Thats

...pots seem very touchy.There is almost nothing on them until they are almost at maximum at which point you get feedback issues.How can I check to see if the pots are operating properly.What should ...

Behringer monitor lost bass You should check the woofer's impedance as a starting point, let me know further. check all components in the crossover

behringuer pmp 5000 turns off Can you elaborate a bit more about what you mean by "turning off?" What are you doing up until that point? Does it do it at certain times, etc.?

no sound and its haming model lx1-x If you mean humming, then that usually points to a power supply problem.

...there some kind of a hard reset that might fix this Hi, the power light should not "blink" at any point. It should always be either on or off when either powered on or off. Sounds as though the ...

each channel and if one fails then it lets that channel die. It requires signal tracing to find the point of failure. It may be a capacitor also