Questions & Answers for: Boss ohm settings

boss 2500d gets hot and trips off and on every 5 mins... I recently bought a boss 2500d. It performs well during the first half an hour then it trips off, and after five minutes it would come back on ...

...of the amplifier must equal the combined resistance of the speakers. So if the amps says 8 ohms and you have two 4 ohm speakers you put them is series or if the amps says 4ohms and you have ...

...amp and not knowing your voice coil impedance I will assume the following. If the speaker is dual 4 ohm voice coil the in parallel it would present a 2 ohm impedance to the amp. If this amp is stable ...

...whats the best way to hook it up to 760pioneer mono amp this is the best way if it is a dual 4 ohm .... this is the best way if it is a daul 2 ohm

...get both amp and the cd player on the same page... And most of all if your subs are wired up to .5 ohm stable, see if your amp do the same... My answer to this ?? Upgrade your amp, Boss audio was ...

...or a couple of wires shorting together and that is causing the amp to overload... also check the ohm's of your speaker set up, remembering that: Two 4 ohm speakers wired in parallel = 2 ohm whilst ...

...either of these sub woofers, you would need to determine how many voice coils it has and how many OHM the voice coil/s are. If it is a DVC (dual voice coil) and each voice coil is 4 OHM or 2 OHM, ...

...itself or do the subs just need to be broke in im not sure make sure your amp can hold either .5 ohms , 2 ohms or 8 ohms...... by my guess your amp is either 2 ohm stable or 4 ohm stable and you ...

...change the overall impedance that the amplifier "sees". If your impedance is too low (let's say 1 ohm) and your amp is only stable to 2 ohms, the amp will shut off to prevent over heating and

If I have a boss 4000 watt 1 ohm amp would that push a 12 w7 As it is 4kW (peak music power) into 1 Ohm you may get 1kW (peak music power) into 3 Ohms. Peak Music Power is four times the actual power ...