Question about 2003 FLHT Electra Glide Standard
...and unplug it, measure the stator side output. I don't know what the values are on your bike since you don't state the model but you should get a reading at idle and as you rev the motor the ...
Question about 2003 FLHT Electra Glide Standard
engine stalls when I pull my clutch in. It only does this after the motor heats up, it runs fine cold. It is a Harley 88ci with a S&S 106 kit. Hi James_s_some, and the usual suspects are: 1. ...
2001 flht stop running when engine gets hot Hi Mikegoudeau, and the usual suspects are: 1. Severely discharged or damaged battery. 2. Loose, corroded or broken battery cable. 3. Alternator not ...
...or dirty ignition module connector at crankcase. 13. Faulty MAP, CKP, and or CMP sensors. 14. Incorrect valve timing. 15. Weak or broken valve springs. 16. Damage intake or exhaust valve. For a ...
...11 at cherokeeHD NC.used once leak`s everywhere!! we are in ontario canada HELP! You can go to Harley's website and get contact information for that shop and call them. Maybe they'll do ...
...Inrichner valve inoperative. 11. Engine lubricant to heavy (winter operation). 12. Ignition not functioning properly possible faulty CKP, CTS or MAP sensor. 13. Faulty ignition coil. 14. Valves ...
...or dirty ignition module connector at crankcase. 13. Faulty MAP, CKP, and or CMP sensors. 14. Incorrect valve timing. 15. Weak or broken valve springs. 16. Damage intake or exhaust valve. For a ...
Question about 2000 FLHT Electra Glide Standard
...or dirty ignition module connector at crankcase. 13. Faulty MAP, CKP, and or CMP sensors. 14. Incorrect valve timing. 15. Weak or broken valve springs. 16. Damage intake or exhaust vale. For a ...
Question about 2000 FLHT Electra Glide Standard
bike dies with no warning/have replaced ALL carb/and related vac lines cleaned tank checked wiring bike does start right away after i shut it off Hi Anonymous, and the usual suspects are: 1. Severely ...
...Inrichner valve inoperative. 11. Engine lubricant to heavy (winter operation). 12. Ignition not functioning properly (possible sensor failure). 13. Faulty ignition coil. 14. Valves sticking. For a ...
Usually answered in minutes!
92 Questions
83 Questions
76 Questions
62 Questions
10 Questions