... Then try to rev up it should rev up without hesitation if not hold down on throttle untill you get max rpm it it tries to cut out etc. at high rpm adj. the H screw until you get max rpm. then adj ...
H screw for max rpm. Then set the L for good idle and little or no hesitation when throttle is opened. Now reset the H for max rpm again. You may have to adj each for a little while to get max results
...newer model Husquarna chainsaw. When I give it extra gas it stalls in the sweet spot. If I give it max gas it cuts off. When I try to saw it wants to cut off also. I changed the gas and tried that ...
...the screw in or clockwise until the rps starts to decrease. Then start turning it out till you hit max idle rpms. Turn screw back in a quarter to half turn and it should be idling smoothly. Be ...
Question about Forest & Garden 125l 18" Gas Trimmer
...the screw in or clockwise until the rps starts to decrease. Then start turning it out till you hit max idle rpms. Turn screw back in a quarter to half turn and it should be idling smoothly. Be ...
...out on each screw, fine tuning will need to be do from there, idle speed should be 3000/3200 rpm, max speed should be
carb ajustments for johnsered 670 Base settings are one and a quarter on the L screw, and thre quarters on the high, you need to check the max rpm with a tacometer, it shpuld not exceed 12500rpm.
...too sure what spec you need, so here is the main things. Bore 45mm Stroke 34mm Idle speed 2700rpm Max top speed 13800rpm Max power 3.0KW@9300 rpm Weight 5.4KG without bar Sound power level 112 dba ...
won't rev up idles fine but won't consistantly hit max rpm i am thinking the coil is going bad check the spark before and after it acts up
...till you get it highest revs,then keep repeating that till you get it idling normal.rev saw up max revs,adjust high speed jet, in or out till you get max revs,then screw out one quater of a ...
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions