Questions & Answers for: GMC S-15 intake manifold gasket

...high idles ,backfires,will not go past 25 mph on any gear here are a few things to check out: egr system your timing intake manifold leak check the distributor cap to see if it is damaged or ...

...or oil around your intake manifold gaskets? specifically lower manifold gasket. you could have a bad intake manifold gasket. that could be your problem. it could be getting in your intake

blown head gasket = a possible bent rod..can I drive it anyway? gmc 1987, s-15, 2.5l..repaired head gasket, changed oil & filter ,also svc'd radiator, oil pressure stays up no leaks of rasiator ...

engine clatters something awful. i changed pushrods and rockers but that didn't help I wouldn't spend any more money on it until I had that engine checked over by a licenced mechanic. It could be ...

litre AT 4x4 The firing order is almost always cast in the intake manifold in front of the throttle body.But here it is 1-6-5-4-3-2....Rotation is clockwise. The cosest front terminal on the cap is #1

1985 2.8L V6 oil pan replacement gasket shows two sizes. One is 1st Design;w/ 5.5mm Thick Rear Main Bearing Seal. The 2nd Design;11mm Thick Rear Main Seal; which one should I use, or does it matter? ...

...intake manifold, often near the thermostat housing. Fig. 1: On most vehicles such as the 4.3L (VIN Z) engine, the coolant temperature sensor is mounted in the intake manifold NOTE: Care must be taken ...

My GMC S-15 needed a water pump so after someone put one on for me they said i still have water leaking .....Where could it be coming from intake manifold gasket.

...manifold 26 ft lbs fly wheel 45-59 ft lbs intake manifold 25 ft lbs knock sensor 14 ft lbs oil pan 6-9 ft lbs rocker arms/valve cover 8 ft lbs water pump 15-22 ft lbs hope this helps you good luck ...

...intake then over that length of time i sure they have been done before the covers are most likely bent instead of using a gasket clean both sides with brake part cleaner hammer the cover as flat as ...