Questions & Answers for: Watts honda generator starts stops running

...generator. It only runs if I hold the start button, when I release it she stops. I have plenty of oil in it and when I disconnect the oil pressure switch and use a Ohm meter on the switch it reads ...

lost electric power to fuel pump on Onan Generator generator will not run there should be a fuse at the housing by the start/stop switch. if deisel then take the 10mm screw out of the coolant cap ...

4000 onan will start and run 5 to 10 minutes and stops . Will start back up and will do the same.Has new oil new air filter new fuel pump and filter carb kit . new battary . new plug . Help check oil ...

5500 marquie gold startes run for a few nim thin 5500 marquie gold startes run for a few min thin stop will not prime for short time thin it will restarts shut fuel off at tank, pull fuel line off ...

i have aonan marquis gold 5.5hgjab on my rv it starts run the first time for 15 to 20 min then stop then will not prim or start for 5 or 10 min like it cool off then restarts run for 5 min then stop ...

...honda generator that is not putting out any ac voltage. It was working fine but when the power came on, it did not get unpluged and after that, I had no a/c voltage. How can I troubleshoot either the ...

generator is reasonably level. If still not resolved, then locate the sending unit, and remove the wire that is on the end of it. There should be a connector either a few inches from the sending unit,

...in the middle (self holding) position. Lower position is to stop the generator. If left in middle position it is not running you may have the switch bad, or the generator is stopped by low oil

...stops immediately after release. Fault code is 15 (underfrequency) and suggests removing heavy loads - but load isn't normally connected until about 30 seconds AFTER gen has been running. Same ...

onan 4000 generator my generator runs ok, but stopped supplying power. during reset of breaker, i checked the oil and it has gas in it. where to start ? Check the rotor slip rings and brushes first, ...