Questions & Answers for: Frigidaire fan cover

...All of them that I have seen have a cardboard cover with slits and and opening for the fan to blow through.It may work ok without it but it is intended to direct the flow of air for proper

...cover and access the fan motor. you should see two small yellow covers at each end of the fan motor. Pull these small covers off and oil the ends of the motor. The small covers are caps for oil tubes ...

...fan it may be vibration and the front cover where the switches are is loose and makeing the noise, gently press on this front cover and see if the noise stops, if so use Duct tape around the edges to ...

I have a replacement fan ordered for delivery 8-16-10. QUESTION: How do I get the old fan out? take out the whole back wall cover to access the fan. this is very straight-forward stuff once you see it

...it. defrost it and see if the fan works. If not, they are fairly inexpensive and easy to replace. There is an access cover on the back wall of the freezer. remove it, and the fan is right behind

...I don't know how to check and see if there is some type of blockage in the air flow system. Behind the freezer cover is a fan make sure that is running .You have to take cover off to get to ...

...but the coils are working You will need to replace the evaporator fan assembly. I didn't see your model number posted but here is a link to the Frigidaire fan kit that should cover all

...cover from the freezer. Remove the wires inside the exposed evaporator assembly from their retaining clips, then squeeze the quick-connect mechanism to detach the wires from the fan ...

...cover. Your fan is located in the back section of the freezer. In this particular model the fan is energized by the ADC(auto defrost Control) which is in the control panel in the fresh food section. ...

...fan cover. the fan supplies cold air for the compartment where the icemaker is located. the error code may be cleared by disconnecting power to the refrigerator for about 3 minutes, then plugging the ...