Questions & Answers for: Behringer dsp button

...button it light up but it not workin This is a wild educated guess. I repaired a Behringer guitar amp that had a DSP effects in it (BX1200 I believe). The effects were on a seperate board and the ...

...thing on a GX110 and it was an electrolytic cap that filters for the 5 volt regulator on the DSP board. As the DSP starts up, the load on the supply sucked it below the operating point and ...

Where can I buy a DSP board to my DCX 2496? E.S. Norway A good place to go is: www.pricewatch.com WBTech

when using the dsp of the mixer after an hour or more of use the is a hissing and scratching and crackleing sound what could be the cause iof this?...the mixer is brand new and only has been used 3-4 ...

...dips in the unregulated voltage that fell below what the regulator needed and the voltage to the DSP fell to the point that the DSP was resetting at twice line frequency. This was ONLY visible ...

Behringer How To Connect iNUKE6000DSP The manual is very clear and if you then still understand it, can you please tell whatt you all want to connect and on which in or outputs. Nobody can do a thing ...

No effects output xenxy 1204fx Likely needs the DSP board replaced. It is the small board held on by 2 screws(if I remember correctly) and is easily replaced. I think retail cost is about $30 and can ...

can i play the inuke 6000 from my computer? can i play the amp from my computer yes

dsp and run stereo mode? Pressing the PROCESS button opens up the various screens that determine the signal path setup and that control processing parameters for the DSP modules: I/O, PEQ, XOVER, DEQ,

how do i put my behringer inuke 6000 dsp in stereo mode? I am trying to run it in stereo mode. I do not need the other stuff,just want to power my full range speakers? Behringer iNUKE NU6000DSP Stereo