Questions & Answers for: Pontiac Grand Am cylinder order

...the back left to right it is 1, 3, 5. Emissonwiz (only the OHV, pushrod V6 was avaliable in 99 unless you had the 4 cylinder) FIRING ORDER FOR THE 3.4 VINE IS 123456. SOUNDS DUMB BUT THAT'S WHAT IT ...

...firing order for a 2000 pontiac grand am se Here ya go: 1,3,4,2 four cylinder firing order 1,2,3,4,5,6 six cylinder firing order post pic of front wheel drive and not rear wheel drive motor

...order...Number 1 cylinder being on the left bank as you face the engine 1994 Pontiac Grand AM 3.1 liter V-6 VIN "M" Good luck...i hope this helps, please rate me a fixya. autozone.com says that the ...

order is 1-2-3-4-5-6.The coils are from the passengers side towards the drivers side.Are 5-2,3-6,4-1.The front 3 cylinders are 2-4-6 and the rear are 1-3-5.The only other thing is The 3.4 did not come

...the 2.4L or 3.4L Engine; however I have included both below. For the 2.4L: Firing Order: 1-3-4-2 Cylinders: .....(back) 1....2.....3....4 .....(front) For the 3.4L: Firing Order: 1-2-3-4-5-6 ...

Cylinder: Firing Order: 1-3-4-2 Cylinders: ..........(back)......... |...1....2....3....4...| ..........(front) For the 3.1L V6: Firing Order: 1-2-3-4-5-6 Cylinders: ......(back)........ |...1....3...

...order is 1, 3, 4, 2 with the #1 cylinder being closest to the drive belt end of the engine. If it is the 3400 V6 then the order is 1, 2, 3, 4, 5, 6 with the odd number cylinders being on the Right or ...

...cylinder: Firing Order: 1-3-4-2 3.1 liter: Firing Order: 1-2-3-4-5-6 For the 2.4L 4 cylinder engine the cylinders are numbered 1, 2, 3, 4 starting from the front of the engine and the firing order is ...

...bled brakes at all 4 wheels (multiple times) changed master cylinder, changed rear wheel cylinders and still have no brake pressure. What is wrong with this car? What order did you replace the items ...

How do I remove the rear brake cylinder? The brake line has been detached. The two screws that hold the cylinder in place have also been removed. There does not seem to be enough room between the hub ...