Questions & Answers for: Toyota Camry clutch master cylinder

...clutch master cylinder and slave cylinder. Before you install the new parts be sure to drain all the old fluid out of the clutch line, and flush the clutch line with brake cleaner and blow compressed ...

...clutch. Check the fluid levels for any or both cylinders. It sounds like your brake master cylinder is starting to leak. Check the brake fluid level and see if it has dropped any. You can rebuild the ...

...master is shot instead I assume its an hydraulic clutch, Check Clutch fluid if full try locating slave cylinder and turn the small screw on it Pump Clutch close screw and pump Then Open And empty all ...

...clutch master cylinder where you checked the fluid to the slave cylinder and pump the clutch three times and hold it to the floor while someone loosens the relief valve you repeat until no air comes ...

...clutch master cylinder may be bad, suggest you replace it, after doing the slave cylinder twice, can't be much else, located on firewall, have you checked the fluid? i'm saying yes, since you've ...

...clutch master problem. You have to replace the clutch master assembly, but you could try first to replace the clutch master repair cap kit( the parts inside can only be replace ) that'll be ...

...clutch master cyl is empty the clutch will not disengage.And if it is empty there is a leak.Possible someone put transmission fluid into the master which would probably destroy the seals.  There ...

...clutch master cylinder ck master for fluid if low fill and work clutch peddle to pump up slave cylinder  if master is full ck at trans to see if slave cylinder is moving if moving clutch in most ...

adjust clutch hydraulic There is no adjustment on the hydraulic clutch. If it is not working properly either bleed out the air in the system or replace the clutch master cylinder.

...clutch master cylinder or slave cylinder...You can do a quick look under driver side dash and see if clutch pedal return spring is broken or disconnected...Look at the top of the pedal...Also look ...