...density that is 4 % or more higher than the target level is detected ten consecutive times during a print cycle, ATVC, or image stabilization sequence. Step Check Item Result Action 1 Imaging Unit Bk ...
...density that is 4 % or more higher than the target level is detected ten consecutive times during a print cycle, ATVC, or image stabilization sequence. The sensor for this error is in the black ...
Density Control sensor error.Please clean the sensor under OPC drum,press the reset switch after open the front door.Enter into service mode (press STOP-0-STOP-1) select F code history ,open and close
...Density Control. A sensor that look at the drum and determines ability of the drum to hold toner and image. Open close front door should reset it. If it comes back clean the sensor, Drum may need to ...
...Density Cotrol sensor malfunction. Clean the optical parts:lens,mirrors and original glass.Remove the OPC unit clean the AIDC sensor under drum in the rear side,use the vacuun cleaner for remove the ...
malfundtion code C0F30 Please specify the model.The COF30 code refer to AIDC sensor(auto image density control).Clean the optics part mirror,lens ansd sensors.
please I want the solution of the code error C0F22 for the minolta EP 3010 CSPRO Check the drum density sensor must remove the drum to clean it.
...clean the AIDC sensoe located under OPC drum,reinstall the drum unit in the copier,enter in the technical Rep mode,place 5 sheets A3 paper on the original glass and perform F5 AIDC sensor(Auto image ...
...Density Sensor code, have you had the developer replaced recently? If so was the counter cleared before running the F8 procedure, If not buy new developer and clear the counter first the remove the ...
...unit. Replace the drum with a new cleaning blade. Ensure the Drum Density sensor is cleaned. And Paper Jam senor. As you can see its not easy. recommended a tech. or purchase download service
Usually answered in minutes!
106 Questions
93 Questions
72 Questions
71 Questions
72 Questions