Questions & Answers for: Jeep CJ7 cap and rotor

...cap, button/rotor and plug wires. i may have screwed up and put the wires out of order on the cap and started it up. of course it would not run. replaced the wires in the correct manner (per haynes), ...

Ad

Question about 1983 CJ7

2 Answers

...cap and rotor on the distributor. I get 12v at the coil, and with the key in run position I get 7v into the cap, but no spark gets to the plugs. I have the 4.2l straight 6 engine, with a carb, all ...

Ad

...cap and check that rotor is aligned with the mark you made. If it is not, remove distributor part way, till you can feel the drive gear just disengage, then turn rotor towards the reference position. ...

...only have 6 volts to my coil. Whats the problem? I have replaced ignition mod. the coil, distributer, new plugs, rotor cap and button. 6 volts to what ?? please explain the problem a bit ...

...cap, rotor and dist., also replaced the ignition control module. It will spark, start and run for 3-5 seconds then stop. Thank you. I would check the carburator. Can you keep it running with starter ...

...cap (often a distributer will have been altered and #1 not located as indicated in the book) this method covers that. So, you need to ground or disconnect the coil wire coil to center of distributer. ...

Question about 1983 CJ7

1 Answer

...rotor dist. cap sparkplugs . in what direction does the rotor turn if you have someone crank the motor with the cap off while you watch the rotor you will know.you don`t say what motor it is so its ...

Question about 1983 CJ7

1 Answer

...5 4 3 2 1 RADIATOR The firing order is 1-8-4-3-6-5-7-2. this is for a 1979= 304 engine, the rotor in dist. turns clockwise, #1 cylinder on cap is facing towards the front of engine. have a good day

Question about 1983 CJ7

1 Answer

...rotor cap, plug wires, cylinder coil next to block and I have no fire? The jeep was firing until all the water got to the carb. Now no fire? What can I check or what have I missed? Thanks, Bill You ...

Question about 1983 CJ7

3 Answers

...cap, and rotor. Could be plugged up catalityc converter. Sounds like a plugged catalytic converter...remove the O2 sensors and start it and see if it bogs down, if it doesn't, replace cat... Could be ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1984 Jeep CJ7
1984 Jeep CJ7

100 Questions

1983 Jeep CJ7
1983 Jeep CJ7

186 Questions

1985 Jeep CJ7
1985 Jeep CJ7

124 Questions

Manuals & User Guides

Loading...